DPS SPS 8 운영 매뉴얼 - 페이지 3

{카테고리_이름} DPS SPS 8에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DPS SPS 8 8 페이지. 8 port serial switch

페이지 인쇄

Start T/ASC MUX

Select the hard drive and the T/Config directory.

Type T/CONFIG <ENTER>.

Highlight T/ASCMUX <ENTER>.

The first screen will request initials. Enter your initials and

press <ENTER>.

Fig. 5 - Main Menu Lists the Functions Available in

T/ASCMUX

Main Menu

The Main Menu (Fig. 5) lists the functions available in

T/ASCMUX. Each of these Main Menu items is explained in

the following paragraphs. Most fields will have an associated

"default box" that appears. To select from the default box press

Tab and use the Tab key or cursor arrows to highlight the de-

sired value, then press <ENTER>.

Fig. 6 - Enter a New Name in the Open ASCII window or

Select from Default Box

Open ASCMUX

This selection is used to open an existing configuration or to

name a new one. When this function is selected a box will ap-

pear with three fields. See Fig. 6 and Table A.

Table A - Field Descriptions in the Open ASCII MUX

Screen

Field

NAME

Enter a new name or select an existing one from the de-

fault box. The name will appear in the Title Bar at the

top of the screen at all times. The name should be exclu-

sive to this configuration.

SITE NAME

Enter a name that describes the location of the unit.

(Mandatory field)

COMMENT

Optional field for additional identifying information,

such as date or initials of preparer.

D-PC-186-10A-XV

September 16, 1999

Description

Fig. 7 - Set ASCII Port Parameters in the Edit

Configurations Screen

Edit MUX Configuration

This selection presents the Edit MUX Configuration screen.

See Fig. 7. Set parameters for each of the eight ports and the

MUX (common) Port in this screen. Parameters and their val-

ues are explained in Table B.

Table B - Field Descriptions for the Edit Configuration

Field

Msg Timeout

Time to delay before aborting incomplete message. En-

ter in tenths of seconds (10-255). Default is 100.

Baud

Off, 300, 1200, 2400 and 9600. Select from default box.

Default 1200 Baud.

Parity

EVEN, NONE, ODD. Select from default box. Default

NONE.

Word Length

7 BITS, 8 BITS. Select from default box. Default is 8.

Stop Bits

1 BIT, 2 BITS. Select from default box. Default is 1.

Interface

TTL, RS232, RS422, RS485, 202. Select from default

box. Default is RS232.

Several "Hot Keys" are available in the Edit MUX Configu-

ration screen. The line at the bottom of the screen lists them.

Table C - Hot Keys in the Edit Configurations Screen

Key

Tab

Select default box.

Up Arrow

Go to previous field.

Go to previous port.

Go to next port.

Save.

Help.

F10/Esc

Go to first field or exit.

Craft Connect

Use this menu item when connecting to the craft port on the

front of the MUX for downloading or other functions.

NOTE: When using this function, the MUX port is not active.

Fig. 8 - Select from Several Craft Port Functions in the

Craft Connect Menu

Screen

Description

OG119699