AMPY 5188A 사용자 설명서 - 페이지 5
{카테고리_이름} AMPY 5188A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMPY 5188A 8 페이지. Cardmeter
페이지 인쇄Cardmeter User Manual ver 008 2016-02-24.doc
3.5
Example 1 – Single Tarrif
3.5.1
Make a note of your standing charge and cost per kWh. For example:
Scottish Power
14.8p per kWh.
Standing charge £24.80 per quarter (divide by 13 to give the weekly
standing charge of £1.91).
3.6
Inputting the settings
3.6.1
Insert and remove the meterman card.
3.6.2
Cycle through the settings using the SETTINGS DISPLAY button until
you reach STCH/WK £000.00
3.6.3
Press and HOLD the EMERGENCY CREDIT button.
3.6.4
Press and Release the SETTINGS DISPLAY whilst still holding the
EMERGENCY CREDIT BUTTON until the correct value is shown.
3.6.5
Release the EMERGENCY CREDIT BUTTON and repeat the process until
all the digits are set correctly. Note you need to set the WEEKLY standing
charge, found by dividing the quarterly standing charge by 13, in this case
£001.91. The resulting display should read STCH/WK £001.91.
3.6.6
Press the SETTINGS DISPLAY button to store the new setting and display
the next parameter.
3.6.7
Repeat setting RATE 1 014.80ppu and if your meter has a setting for two
rates, then set RATE 2 014.80ppu. On single rate meters, you will only
need to set RATE 1.
3.7
Example 2 – Dual Tarrif
3.7.1
Make a note of your standing charge and cost per kWh. For example:
Scottish Power
14.8p per kWh Normal (day) rate.
3.8 per kWh Low (night) rate.
Standing charge £24.80 per quarter (divide by 13 to give the weekly
standing charge of £1.91).
3.8
Inputting the settings
3.8.1
Insert and remove the meterman card.
3.8.2
Cycle through the settings using the SETTINGS DISPLAY button until
you reach STCH/WK £000.00
PAGE 9 of 16
Cardmeter User Manual ver 008 2016-02-24.doc
3.8.3
Press and HOLD the EMERGENCY CREDIT button.
3.8.4
Press and Release the SETTINGS DISPLAY whilst still holding the
EMERGENCY CREDIT BUTTON until the correct value is shown.
3.8.5
Release the EMERGENCY CREDIT BUTTON and repeat the process until
all the digits are set correctly. Note you need to set the WEEKLY standing
charge, found by dividing the quarterly standing charge by 13, in this case
£001.91. The resulting display should read STCH/WK £001.91.
3.8.6
Press the SETTINGS DISPLAY button to store the new setting and display
the next parameter.
3.8.7
Repeat setting RATE 1 014.80ppu and RATE 2 003.80ppu.
PAGE 10 of 16