DPS Telecom Net Dog 82 IP 운영 매뉴얼 - 페이지 12
{카테고리_이름} DPS Telecom Net Dog 82 IP에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DPS Telecom Net Dog 82 IP 12 페이지.
페이지 인쇄
Downloading Firmware
Firmware upgrades are provided either on disk or via
modem. They are downloaded at the COM1 port using
DPS Load software, which is included with the firmware
upgrade file. Use the following procedure to upgrade
your Net Dog's firmware:
1. Load the upgrade file on your PC.
2. Connect the serial port of your PC to COM1 on the
Net Dog.
3. Start the DPS Load program.
4. Cycle the power on your Net Dog.
5. While the Net Dog LEDs are displaying the flashing
on/off pattern for approximately six seconds after
power up, start to download the file.
6. When finished, normal operation will resume.
7. Disconnect your computer.
Net Dog MIB Installation
To enable your SNMP manager to receive and inter-
pret the TRAPs sent by the Net Dog, the MIB provided
with the Net Dog must be compiled into the SNMP
manager's MIB. Refer to your SNMP manager's operat-
ing manual or your SNMP support group for instructions
regarding this procedure.
Options and Model Numbers
D-PC-295-10A-01
Net Dog 82 IP, 120 VAC
D-PC-295-10A-02
Net Dog 82 IP, -24 VDC
D-PC-295-10A-04
Net Dog 82 IP, -48 VDC
Shipping List
• Download cable (D-PR-045-10A-02)
• Power cable/transformer* (D-PR-107-10A-00)
• Operation guide (OG113939.001)
• Mib-trap file disk (D-SW-790-10A-00)
• Ethernet cable (8ft. RJ45 to RJ45) (D-PR-923-10A-08)
• DPM mounting kit (1-005-0001-00)
• Mounting template
*Transformer cable only available with AC option
D-PC-295-10A-0V
May 5, 2000
Specifications
Dimensions:
8" W x 7" L x 1.5" H
Mounting:
Keyhole pattern on the back allows
mounting on a wall, frame or
rack panel.
Power Input:
-24VDC model (-18 to -36VDC)
Max Current: 300 mA
-48VDC model (-36 to -72VDC)
Max Current: 180 mA
Fuse:
Internal 300 mA
Operating
Range:
0°-60°C (32°-140°F)
Humidity:
0% to 95% non-condensing
Interfaces:
1 DB9 ASCII port, 1 RJ45 Ethernet
port, 1 RJ12 telephone line port, 1
power plug.
Modem:
33.6 "AT" type
Protocols:
SNMP on LAN/WAN port,
TAP (alpha) paging, numeric
paging, T/MonXM reporting
and text messages on modem port.
Control
Outputs:
Relay contacts, 2 each, form A
Max. Voltage = 60 VDC/120 VAC
Max. Current = 1 Amp, AC or DC
Alarm Point
Inputs:
8 discrete
Ping Target
IP Addresses: 32
12
OG113939.001