Amp’ed RF Technology BT-AP111 사용자 설명서 - 페이지 7
{카테고리_이름} Amp’ed RF Technology BT-AP111에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amp’ed RF Technology BT-AP111 12 페이지. Bluetooth to ethernet bridge
Amp’ed RF Technology BT-AP111에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지)
페이지 인쇄4. Status & Configuration
When you are on home page it is displayed above. This web page described the current status of the BT-AP 111.
In a top table the list of property described like the name, Firmware Revision, Inactivity timeout, IP address and MAC
address.
1) Name
You can provide user defined name use of Misc Settings property. Default set to Bluetooth Access Point.
2) Firmware Revision
Which provide you firmware version installed in BT-AP 111. Users are not able to update firmware; they need
to contact our customer support
3) IP Address
Assigned IP address to BT-AP 111.
4) MAC Address
Assigned MAC address to BT-AP 111.
5) Inactivity timeout
It is related with the connection between client to server , If inactivity occurs 20 minutes long than it causes
timeout or connection refused.
In a Telnet port settings table long list of property described like Baud Rate, Data Size, Parity, Stop bits, Flow
control, Local Telnet Port number, Remote Telnet Port Number, Telnet Mode, Telnet protocol, Telnet Server
IP and Telnet Timeout.
6) Local Telnet Port Number
port is generally a specific place for being physically connected to some other device, usually with a socket
and plug of some kind. It is useful to provide unique port number to access the BT-AP 111. User can provide
Telnet Port Number use of Telnet Settings.
7) Remote Port Number
port is generally a specific place for being remotely connected to some other device, usually with a socket
and plug of some kind. To access the BT-AP 111 remotely you need to specify it's port number else it
defined "N/A". Note: when Telnet Mode set to "client", afterwards you can defined Remote port number else
leave it.
8) Telnet Mode
This mode defined the remote device or machine work as "server" or "client", default value is "server".
9) Telnet Protocol
TELNET is a network protocol used on the Internet or local area networks to provide a bidirectional
interactive text-oriented communications facility via a virtual terminal connection. User data is interspersed
in-band with TELNET control information in an 8-bit byte oriented data connection over the Transmission
Control Protocol (TCP). When User set the Telnet Mode to "server" you have to set Telnet Protocol to
"Telnet" else it is generating erroneous transmission over network. When you are setting the Telnet Mode to
"Client" at this time please try to change Telnet Protocol to "RAW".
10) Telnet Server IP
When the Telnet Mode sets to "Client", you can specify the Telnet Server IP for telnet server.
11) Telnet Timeout
It is specifying inactivity of the telnet after specified seconds. Default is a "0" it means there is no timeout
session used.
©2010 Amp'ed RF Technology
09/10/2010
1879 Lundy Ave, Suite 138, San Jose, CA 95131, USA
www.ampedrftech.com
Amp'ed RF Technology, Inc.
(phone) 408 213-9530
(fax) 408 213-9533
BT-AP 111 Datasheet
Page 7 o f 12