Amrotec MiB-9 매뉴얼 - 페이지 3

{카테고리_이름} Amrotec MiB-9에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Amrotec MiB-9 7 페이지. 2 pocket discriminator
Amrotec MiB-9에 대해서도 마찬가지입니다: 핸드북 (2 페이지), 운영자 퀵 핸드북 (2 페이지)

페이지 인쇄

4. In "IP address", you must enter the IP address of the machine and change the last set of numbers

(last 2 digits) (eg. if machine IP address shows 192.168.10.50, change last 2 digits 50 to anything

above 01, but, avoid the same IP address as the machine. You can set as 192.168.10.70 as an

example)

a. To find machine IP address press 9[Menu] > 5.Interface > 4.IP address > 1.Machine IP

address. Please enter the same IP address shown on the machine to the above.

5. In "Default gateway", enter the machine IP address but change the last set of numbers to 1 (eg.

192.168.10.1). Please OK and Exit. Machine at this point should be connected to your PC. If it is

connected or not, see page 5 VolX program screen where machine IP would show up, means,

machine is connected properly.

6. For data sampling, please proceed with steps below Î

Step #1: [Selection of Proper settings on MiB-9]

1) First, make sure that MiB-9 machine is connected to the PC using RJ45 connector (LAN Port) as

described in above steps 1-6.

2) Once properly connected through proper cable, please select correct image settings options on the

machine in order for capturing correct images required for banknote data sampling.

Press [MENU] key Î [MODE] key on the MiB-9 control panel to enter into the

8.System Setting Î 1.Image Down Setting as shown in the images below

Î Î

Service Menu 1 Î