AMS TSL2585 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} AMS TSL2585에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMS TSL2585 9 페이지. Miniature ambient light sensor with uv and light flicker detection

Software Installation

Plug the flash drive into an unused USB port

Double-click the Setup.exe file on the flash drive, or click Start > Run and type E:setup.exe and

press Enter. IMPORTANT: Use the appropriate drive letter in the above command to install the

software. Flash Drive will commonly be assigned the next available drive letter for example C:

hard drive, D: CD-ROM, E: flash drive

The Setup Wizard will open and guide you through the installation of the TSL2585 host

software, (Figure 2 through Figure 8)

The EVM Controller board requires the installation of FTDI CDM drivers. If these drivers are not

installed on your machine, this setup will automatically launch the installer for the FTDI drivers.

At the end of the installation, click Finish to exit the setup.

Figure 2:

Welcome Screen

Quick Start Guide • PUBLIC

QG001010 • v2-00 • 2021-Sep-13

Document Feedback

Figure 3:

Liability Disclaimer

TSL2585 ● TSL2585 EVM

Software Installation

│ 4