Comelit DT12EAM 매뉴얼 - 페이지 14

{카테고리_이름} Comelit DT12EAM에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Comelit DT12EAM 15 페이지. Dual-tech sensor antimask function

11 Test procedures
Walk Test
Make sure LEDs control is set to "ON"
Allow 30 seconds of warm up time.
Make sure that the protected area is cleared of all people.
Start walking across the detection zone.
Look at the LEDs whenever motion is detected - all LEDs are turned ON.
Allow 5 sec. between each test for the detector to stabilize.
Upon installation, the unit should be thoroughly tested to verify proper operation.
Walk across the entire area where coverage is desired. Should the coverage be incomplete,
readjust sensitivity or relocate the detector.
Once coverage is as desired the LEDs may be disabled.
NOTE: Walk Test procedure should be conducted, at least once a year, to confirm
proper operation and coverage of the detector.