1byone 203NA-0007 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} 1byone 203NA-0007에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 1byone 203NA-0007 2 페이지. Remote control 360deg rotation vhf & uhf infrared tv antenna

1byone 203NA-0007 빠른 시작 매뉴얼
SPECIFICATION
-
No. of
Amplifier
Beam Width
Elements
Gain
H/V
170-230MHz
3-5d
Bi
6
15dBi
H60°/V60°
470-862Mhz
7-
10dBi
How To Install
A
B
C
A
B
C
Step 1
: Unfold the antenna booms until they stay in horizontal orientation. (Refer to graph A and B)
Step 2
Front-Back
: Connect the UHF Enhanced Reception Element with the antenna by using screws. (Refer to
graph B)
5-10dBi
440mm
8-13dBi
Step 3
: Mount the antenna to the pole with the connecting part as high as possible and point the
antenna towards the TV tower for the best reception. Then connect the other end of the
coaxial cable to the F connector on the PSU marked "IN".
Please reserve a certain length of cable in case it is pulled due to rotation.
TV
Step 4
: Connect the port on the PSU marked "TV" to the antenna input on your set-top box or HDTV
using the included 1.5-meter 3C2V Coaxial Cable.
Step 5
: Plug the PSU into a socket, turn on your TV and run a channel scan. If you're not receiving all
your local channels, you can adjust the direction of the antenna by long-pressing the
remote control or the push button on the power supply unit. The antenna can complete a
full 360° rotation.
Note:
1. Remember do a channel scan every time you change the antenna's direction.
2. There is no battery included in the remote control. Please insert the correct battery type. Batteries are
not included.
3. The antenna will rotate when you long-press the button on the remote control or power supply unit. If
you stop pressing or press just for a few seconds, the antenna will not rotate. Please remember to
long-press it.
里面
A. In the TV's setup menu, set the mode to 'Antenna' or 'Air.' . Refer to the TV manual for detailed
B. While in the TV' s setup menu, set TV to scan for channels. This can sometimes be listed as
TV reception and quality depends on the distance from the transmitting tower to your home.
Surrounding environments may also a ect signal strength and reception.
If your reception is sporadic or needs to be improved, try the helpful tips below:
1. Placing the antenna in a higher location may result in better reception.
2. Facing the antenna towards the broadcast tower may result in better reception.
Important: Always re-scan for channels whenever you move your antenna.
How many channels can I receive?
The number of channels you can receive will be determined by what is being broadcast in your area.
Channel reception will vary from location to location based on terrain (including trees, buildings,
hills and mountains). The fewer obstructions, the better your chance of receiving strong digital
signals. Go to http://dtv.gov/maps and enter your address for a listing of likely channels
Recommend to reserve
available in your area.
6 to 8 inches (15 to 20 cm)
Will all the channels I receive be High De nition (HD)?
Cable Ties
Not all digital signals are High De nition (HD). Make sure you are using a High De nition Television
(HDTV) with built in ATSC tuner. When connecting the antenna to a third-party receiver, make sure it
is capable of receiving HD. Otherwise no HD channels can be picked up.
TV
One channel is missing.
1. Something may be obstructing the signal. Move the antenna, then re-scan for channels.
2. Try long-pressing the remote control or the push button on the power supply unit. The antenna
The picture or sound freezes while I am watching a channel, or there are boxes in the
picture.
1. This is often caused by a weak or intermittent signal. Try moving the antenna to a di erent
location or aiming it in the direction of the broadcast tower for that channel.
Place your 1byone® antenna in the location with the strongest reception. To check the exact
distance from your residence to the nearest tower, go to http://dtv.gov/maps and type in your
postal code. You will then have a better idea of what you should expect in the way of reception. If
there are multiple tower locations, optimize the position of your antenna by pointing it in the
direction of the weakest signal (usually the farthest away from you).
Scan the TV for Channels
instructions.
'auto-program,' 'channel search,' or 'channel scan.' Consult your TV manual for detailed instructions.
Antenna Placement Options and Tips
Frequently Asked Questions
can complete a full 360°rotation. Then you can scan for channels.
For Optimal Performance