AmScope AM-1 Series 사용자 설명서 - 페이지 11

{카테고리_이름} AmScope AM-1 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AmScope AM-1 Series 19 페이지.

SM-1 Series

1. First, take the styrofoam container out of the cardboard carton and lay it on its side, paying attention

to which side is labeled up. Remove the tape and open the container carefully so as to avoid dropping

and damaging the optical items. Check carefully to ensure that all parts and accessories are intact.

2. Check the packing list to ensure that you're received all items. Please note that this can vary

depending on which model you've purchased, and is generally listed on www.amscope.com at the

items' details page for your specific model.

3. Remove the microscope body from the box and remove the plastic protective covering. The body of the

microscope is composed of the base that comes with your unit, the focusing rack, and the head lock

screw.

For –PL model, insert the illumination device① in the bracket

and tighten the lock screw②. Insert plug into the socket③ of the

pillar stand.

5. After mounting the focusing rack to the base (if not already

attached in shipping), slide the objective of the microscope into

the hole and secure with included head lock screw.

6. For the -T models, screw the photo port onto the top of the

microscope head (trinocular C-mount port).

7. Remove the eyetube caps and drop the desired eyepieces into the eyepiece ocular tubes. Be sure

to avoid touching the lens to ensure no artifacts appear in your image.

8. Remove the cap from the objective lens.

9. Plug in the microscope and turn it on if a light source is included (or refer to your specific light

source instructions for mounting/turning on if an external source). If no light emerges from the

light source, adjust the dimmer knob near the power switch.

10. If viewing an opaque sample, use a top light source, however while using a translucent sample,

either light source can be used.

Getting Started