AMSEC ESL20XL 사용 설명서 - 페이지 4
{카테고리_이름} AMSEC ESL20XL에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMSEC ESL20XL 10 페이지. Electronic lock
페이지 인쇄
American Security Products Co.
After the first User keys a valid combination, a short warbling tone is sounded, and the second User is then
o
required to key a valid code.
If no second code is keyed within 10 seconds, the lock goes to the resting condition and the process must be
o
started again.
The two User Codes must be different Users.
o
A complementing feature can be enabled (F31) that prevents two subordinate Users from opening the safe. If
o
this mode is Enabled, the Manager must be one of the two Users entering valid combinations.
Duress Alarm - This feature allows a User to secretly signal that they are under Duress, typically in the act of being
forced to open the safe in a robbery situation.
This feature must be Enabled (F20).
o
This feature requires that one of the optional Expansion Modules (ESL20EXP1, ESL20EXP2 or ESL20EXP3) is
o
attached to provide electrical connection to external systems like alarms and monitoring services.
When a User keys a combination, finishing the code entry with the last number of the combination either 1
o
digit high, or 1 digit low, Duress output relay in the Expansion Module responds with a contact closure of for
one (1) second.
The Lock opens normally, allowing the User to open the safe, without revealing they have sent a silent alert.
o
This Duress output contact closure is the same as if someone had pushed a "panic" button to summon help.
o
By signaling secretly at the safe, the User doesn't risk angering the robber and risking possible personal injury.
External Control - This feature allows the ESL20XL to be disabled and enabled by an auxiliary device like an Access
Manager, a Key Switch, external Alarm System, or any other external switching method.
This feature must be Enabled (F50).
o
To use this feature, you must install an optional Expansion Module (ESLAC, ESL20EXP1 and ESL20EXP2), which
o
provides terminals for external device input connection.
When the External Control Mode is Enabled and the Lock Enable input circuit is OPEN, the lock will not open
o
when a combo is entered, it will indicate with a quick 4 beep/flash.
When the External Control Mode is Enabled and the Lock Enable input circuit is CLOSED, the lock will open
o
normally when a combo is entered.
The external switching that closes the Input should be a dry-contact relay. Solid State switching (MOSFET)
o
from an external device (Alarm system) will Fproperly if polarity is correct.
The Factory Reset Code will clear this condition if it was set accidentally.
o
Reset All Functions - A function has been provided to reset all the functions to what is considered "default" settings.
It disables all of the various modes, deletes all the Users and their codes, and cleans up any unknown settings.
This feature is executed by F99, and a confirming acknowledgement.
o
This is useful tool to get a fresh start after programming has been lost track of or for personnel changes at the
o
Master User level.
Revision A
ESL20XL Operating Instructions
Page 4 of 10
Released Aug. 9, 2018