DR. Heater DR-966 소유자 매뉴얼 - 페이지 7

{카테고리_이름} DR. Heater DR-966에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DR. Heater DR-966 13 페이지. Wall / ceiling mount heater
DR. Heater DR-966에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

페이지 인쇄

INSTALLING INSTRUCTIONS

WARNING:

All wiring must be installed by a certified electrician

according to the electrical safety.

The ceiling heater must be grounded in accordance with all national

and local building codes.

All Wiring procedures and connections shall be in accordance

with the national and local codes having jurisdiction.

Before installation:

Disconnect the main supply connection.

Supply cables shall be 10 AWG (5.3 mm

) copper wires

The heater must be connected to individual branch circuit protected

by 35 Amp circuit breaker only.

Supply cables must be equipped with a dual pole circuit breaker

rating at least 240V 35A/pole as main cutoff switch of power

connection to the heater.

CAUTION

: High temperature, risk of fire, keep electrical cords,

drapery, furnishings, and other combustibles at least 3 feet (0.9 m)

from the front of the heater and away from the side and rear.

WARNING:

To reduce the risk of fire, do not store or use gasoline

or other flammable vapors and liquids in the vicinity of the heater.

INSTALLATION INSTRUCTION:

1. Keep the unit at least 8 feet (2.4m) away from the floor. This

minimum distance must be maintained.

2. Do not install closer than1 foot (or 0.3 m) to any adjacent vertical

surfaces or walls.

3. Keep at least 4.5 inches (11.5cm) from the back wall (with or

without using the wall hanging mounting bracket).

4. Mark the drill-hole positions in the wall or ceiling for the mounting

bracket.