Electrolux 216802800 사용 및 관리 매뉴얼 - 페이지 39
{카테고리_이름} Electrolux 216802800에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 216802800 40 페이지. Side-by-side refrigerator
페이지 인쇄
Solutions To Common Problems
Ice Dispenser
Problem
Cause
• Water supply is not connected.
Dispenser will not
dispense ice.
• Ice storage container is empty.
• Freezer temperature is set too warm.
• Household water line valve is not
open.
• Freezer door is not closed.
• Ice dispensing arm has been held in
for more than 4-5 minutes.
Ice dispenser is
• Ice has melted and frozen around
jammed.
auger due to infrequent use,
temperature fluctuations, and/or
power outages.
• Ice cubes are jammed between ice
maker and back of ice container.
• Ice cubes are frozen together.
• Ice cubes are hollow or smaller than
normal.
Water Dispenser
Problem
Cause
Dispenser will not
• Water supply is not connected.
dispense water.
• Household water line valve is not
open.
• Freezer door is not closed.
• Ice & water filter cartridge is clogged.
• Front filter not fully installed, if
equipped
• Water has been in the tank for a
Water has an odd
taste and/or odor.
period of time.
• Unit not properly connected to cold
water line.
• Tubing used in the household water
supply and installation may affect
water taste and odor.
• Water has a high mineral content.
Water pressure is
• Cut-off and cut-on pressures are too
extremely low.
low (well systems only).
• Reverse osmosis system is in
regenerative phase.
Correction
• Connect water supply (see page 9).
• When the first supply of ice is dropped into the container,
the dispenser should operate.
• Turn freezer control to a higher setting so that ice cubes
will be made. When first supply of ice is made, dispenser
should operate.
• Open household water line valve. Allow sufficient time for
the ice to be made. When ice is made, the dispenser
should operate.
• Ensure freezer door is closed.
• Motor is overloaded. Motor overload protector will reset in
approximately 3 minutes. Ice can then be dispensed.
• Remove ice container, thaw, and empty the contents.
Clean container, wipe dry, and replace in proper position.
When new ice is made, dispenser should operate.
• Remove ice cubes that are jamming the dispenser.
• Use the dispenser often so that cubes do not freeze
together.
• The ice & water filter cartridge could be clogged. Replace
the filter cartridge. Dispensing system operates best at 20-
100 psi water pressure. Well water pressures should fall
within this range.
Correction
• Connect water supply (see page 9).
• Open household water line valve. See Problem section Ice
Maker Is Not Making Ice.
• Ensure that freezer door is closed.
• Replace filter cartridge.
• Push filter in until you hear a "click". Filter should be flush
with cabinet.
• Draw and discard 10-12 glasses of water to freshen the
supply and completely rinse out the tank.
• Connect unit to cold water line that supplies water to the
kitchen faucet.
• For best results, use copper tubing for water connections.
• Contact water treatment plant for help.
• Have someone turn up the cut-off and cut-on pressure on
the water pump system (well systems only).
• It is normal for a reverse osmosis system to be below 20
psi during the regenerative phase.
39