Electrolux 241721800 사용 및 관리 매뉴얼 - 페이지 16

{카테고리_이름} Electrolux 241721800에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 241721800 25 페이지. Electrolux side-by-side refrigerator use & care guide

페이지 인쇄

PureSource

Ice and Water Filter (some models)

NOTE: If you purchased a refrigerator with a PureSource

and care information.

located in the upper right back corner of the fresh food compartment.

System Startup:

Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter

cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section

to properly fill the system with water.

Order new filter cartridges through the

dealer where you bought the refrigerator

or contact the Electrolux Customer Care

Center . It might be good to order some

filter cartridges when you first install your

refrigerator. Be sure to ask for the RG-

100

PureSource™

cartridge.

The PureSource™ NGRG-

2000 Ice and Water Filter

System with the RG-100

cartridge is tested and

certified by NSF International,

the nationally recognized and respected,

not for profit, certification organization for

public health safety. The PureSource™

system is tested and certified to ANSI/NSF

Standard 42. See performance data sheet

for specifications. This system should not

be used on water that is microbiologically

unsafe or with water of unknown quality

unless the water has been adequately

disinfected before or after traveling through

the filtration system.

• Rated Capacity - 1514 liters

• Rated service flow - 1.9 liters per minute

• Maximum Rated Pressure - 6.9 bars

• Maximum Operating Temp. - 37.8° C

Automatic Ice and Water Dispenser

This ice and water filter system filters water to your ice maker and water dispenser. It is

Changing the Filter:

Water conditions vary throughout the world, but changing the water filter every

6 - 9 months normally will ensure the highest possible water quality. The Filter

Status light will turn red after 400 gallons of water has flowed through the ice

and water dispenser (some models). Also, if the filter has been in a refrigerator

that has not been in use for awhile (during moving for example), change the

filter before reinstalling the refrigerator. The dispenser system will also operate

without filtration (with filter cartridge removed).

To change filter:

It is not necessary to turn the water supply off to change the filter.

1. Open freezer door and leave open until filter change is complete.

2. Turn the ice maker's power switch to the Off ("O") position (See illustration

on page 14).

Hold filter cup firmly, and unscrew towards left (Some water could

leak out as you remove cup. This is normal.). Filter cartridge should come

down with cup. If cartridge remains in housing, pull down gently, while

twisting filter back and forth.

Rinse out cup under running water.

The large o-ring that seals the filter system sets in the o-ring groove

down inside the cup. Should the o-ring fall out during filter cartridge

replacement, simply place it back in the groove prior to screwing the cup

back in place. If the o-ring becomes damaged, you will need to order one

from the Customer Care Center .

Discard old filter cartridge.

Remove new filter cartridge from packaging and place in cup. The end

with the small o-ring should be up, out of the cup.

Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall

replacement

Cup. Filter cartridge will self-align as cup is tightened. Be sure cup is

completely tightened with PureSource™ logo facing outward. Do Not

Tighten Past Stop.

Turn the ice maker's power switch to the On ("I") position.

10. Check for leaks. Open refrigerator door. Wipe any water droplets from the

filter cup. Fill a glass with water. If there is a leak, unscrew filter cup, and

reinsert the filter cartridge. Check placement of large O-ring. Reinstall

filter cup, making certain it is tightened completely.

11. To condition filter system and purge air from water line, fill a glass with

water. Continue flushing the system for approximately 3 minutes to assure

that the purest water possible is stored in the water tank.

IMPORTANT: Resetting The Filter Status Light (some models)

After replacing the filter cartridge, it will be necessary to press the Filter

Status reset button located on the ice and water dispenser. This will reset

the Filter Status light. Push the reset button until the green, red and amber

lights flash (10-15 seconds). Please refer to the complete dispenser

operating instructions attached to the inside of the freezer door.

On models without a Filter Status reset button, there is a set of

Reminder Stickers included in the envelope that the Use & Care Manual

came in. Choose a dated sticker that indicates 6 - 9 months (depending

on your water quality and usage) from the date of installation. Place the

sticker on the front of the filter cup to remind you when it is time to

change the filter.

Ice and Water filter, please read the following use