Electrolux Built-In Dishwasher 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Electrolux Built-In Dishwasher에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux Built-In Dishwasher 28 페이지. Built-in oven
Electrolux Built-In Dishwasher에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (36 페이지), 사용 및 관리 매뉴얼 (44 페이지), 설치 지침 매뉴얼 (28 페이지), 사용 및 관리 매뉴얼 (40 페이지), 사용 및 관리 매뉴얼 (27 페이지), 사용 및 관리 매뉴얼 (12 페이지), 사용 및 관리 매뉴얼 (22 페이지), 팁 및 레시피 (36 페이지), 사용 설명서 (18 페이지), 오워 매뉴얼 (21 페이지), 오워 매뉴얼 (13 페이지), 소유자 매뉴얼 (29 페이지), 사용자 설명서 (27 페이지), 지침서 (17 페이지), 지침서 (15 페이지), 지침서 (18 페이지), 지침서 (27 페이지), 지침서 (18 페이지), 서비스 매뉴얼 (50 페이지)

Operating Instructions

ENERGY OPTION SELECTIONS

Hi-Temp Wash

When HI-TEMP WASH option is selected, the dishwasher heats water in the main

wash to approximately 140°F (60°C).

This increase in water temperature helps dishwasher detergent remove food,

grease and soil from dishes more effectively and aids in drying. HI-TEMP WASH

option can be used with all cycles except RINSE.

When HI-TEMP WASH option is selected, the light surrounding the pad will come

on and remain on until end of cycle.

To turn off the HI-TEMP WASH option, press the pad a second time. The light

surrounding the pad will turn off.

Sanitize

To sanitize your dishes and glassware, select the SANITIZE option. When selected,

the light surrounding the pad will remain lit until the START/CANCEL pad is pressed

or the door is closed. This option heats the water temperature in the final rinse to

155°F (68°C) and maintains that temperature for 9 minutes. SANITIZE is available

in Auto Wash, Heavy Wash, Normal Wash and Short Wash cycles. Only these

sanitization cycles have been designed to meet NSF requirements.

The cycle time will be extended until the proper water temperature is reached.

Washing action will continue during the water heating delay. For best results, the

incoming water temperature should be at least 120°F (49°C).

The light surrounding the pad will not illuminate at the end of the cycle if the NSF

requirements for sanitization are not reached. The sanitization criteria may not be

satisfied if there is an interruption of the cycle, a power failure occurs, or if the

incoming water temperature is below 120°F (49°C).

To turn off the SANITIZE option, press the pad a second time. The light surrouding

the pad will turn off.