Electrolux C40/110 매뉴얼 - 페이지 23

{카테고리_이름} Electrolux C40/110에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux C40/110 29 페이지.

6.7.2

Separate fume extraction

3. Insert flue pipe (C) through the aperture.

4. Connect flue pipe (C) to T-piece (E). If necessary, shorten flue pipe (C) to the

required length.

5. Pack the cut with non-flammable material (e.g. Rock Wool).

6. Screw securing plate (D) into position.

7. Put cap (B) on flue pipe (C).

8. Screw on outer plate (A).

6.8

Gas installation

The rules in point 6.1 must be adhered to.

When running on gas, these appliances are intended exclusively to use

liquid gas (propane/butane) - under no circumstances should town gas or

natural gas be used (EN 27418).

A fixed, pre-set pressure regulator complying with EN 12864 must be

connected to the liquid gas cylinder.

The pressure regulator must concur with the operating pressure specified

on the data plate of the appliance. The operating pressure corresponds to

the standard pressure of the country of specification (EN 1949, EN 732).

Only one connection pressure is permissible for any one vehicle. A plate

showing the permanent, clearly legible notice must be displayed in full view

at the point where the gas cylinder is installed.

The gas connection (1) to the appliance must be installed securely and at

zero potential using tube connectors and must be securely connected to the

vehicle (a hose connection is not permissible).

Inflamable material should not be in immediate proximity to the burner.

Cut:

80mm high

40mm wide

1. Cut an 80mm x 40mm rectangle in the outer

wall of the caravan. The position of the cut

must be appropriate to the particular model

of refrigerator and installation conditions.

2. Connect T-piece (E) to adaptor (F) or flue

pipe (K) as required and affix with screw

(G). Ensure that heat distributor (H) is

lodged in the correct position.

min. 10 mm

max. 20 mm