AirSource 3000 소유자 매뉴얼 - 페이지 5

{카테고리_이름} AirSource 3000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirSource 3000 9 페이지. Purification system

If you intend to use the unit in an area exceeding 3,000 square feet in size or if

you have rooms that are segregated, you should consider an additional AirSource

3000 unit. However, do NOT place more than one air treatment unit in the

same room.

Important: Placing the unit too close to a wall or on certain material may contribute

to a localized dusting effect because the unit can pull particulate out of the air

and certain materials generate a charge that attracts the particles. Formica and

laminated wood may be more likely to develop this effect. For best results, place

the unit on bare wood, such as a stained oak bookcase or place an insulating

material such as paper, wood, hard rubber, or Mylar between the unit and the

surface it sits upon. Avoid placing the unit on metal, plastic, wool, fur, carpet,

silk, or nylon, and place it at least 12 inches away from vertical surfaces.

While the unit is very effective at reducing airborne particles from the breathing

space, very heavy particle loads may burden the unit, requiring necessary

maintenance by the AirSource Warranty Service Center to maintain the unit's

effectiveness. Examples may include heavy tobacco smoke (such as a cigar lounge),

frequent candle burning, use of a kerosene lamp, ﬁreplace, or unvented stove

burning, several long haired pets, and hobbies, such as woodworking and ﬁnishing.

Positioning the unit away from these activities should reduce the direct effect on

the unit, while still providing beneﬁt by dropping the particles out of the rest of

the breathing space away from the unit. Dust the unit with a damp cotton cloth —

using water only — as part of your normal cleaning activities. Vacuuming the vents

of the unit will remove most of the dust build up.

Cleaning

Unplug the unit and use a water-dampened cloth to remove dust particles that

may accumulate on the unit. Do not use harsh detergents, abrasives, furniture

cleaner, solvents, or polishes. Do not spray water or cleaners directly on the unit.

Replacing the Photohydroionization

Module

To replace the Module:

Step 1 .

Switch the unit off.

Step 2.

Remove the old Module by turning the screw counterclockwise and slowly

backing the Module out until it is completely disengaged. Discard the

old Module.

Step 3.

Insert the new Module into the unit and turn the screw clockwise until

Module is ﬂush with the outer wall. Do not over-tighten.

Step 4.

Switch the unit on. If the light doesn't come on, check the ﬁt of the

Module and tighten the screw if necessary.

Please contact your AirSource representative to purchase your replacement

Photohydroionization Module. Item Code #55103.

™