AirSource CustomAir 설치, 운영 및 유지보수 지침 매뉴얼 - 페이지 8
{카테고리_이름} AirSource CustomAir에 대한 설치, 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirSource CustomAir 20 페이지. Air handling units, airsource heatpumps
페이지 인쇄
Assembly of Multiple Sections
2)
Pull the two unit sections together along the baseframe at the bottom of the
Pull the two unit sections together along the baseframe at the bottom of the
Pull the two unit sections together along the baseframe at the bottom of the
unit using sash clamps or ratchet straps/chains, using the internal corner plates to
unit using sash clamps or ratchet s
aid alignment (One section should slot into the other). CAUTION: Before drawing
aid alignment (One section should slot into the other). CAUTION: Before drawing
aid alignment (One section should slot into the other). CAUTION: Before drawing
together, ensure nothing will get trapped in the space between each section.
together, ensure nothing will get trapped in the space between each section.
together, ensure nothing will get trapped in the space between each section.
3)
Once the unit has been pulled
Once the unit has been pulled
together, install assembly bolts
er, install assembly bolts
through the corner fixing plates
through the corner fixing plates
on the inside of the unit. For each
on the inside of the unit. For each
corner, tighten the bolts, ensuring
corner, tighten the bolts, ensuring
good compression of the foam
good compression of the foam
sealant/silicone seal on all mating
sealant/silicone seal on all mating
faces of the frame.
4)
Apply silicone seal to
Apply silicone seal to
outside edge to prevent
outside edge to prevent
ingress of water/dirt into the
ingress of water/dirt into the
gap, as highlighted.
7
Installation, Operation & Maintenance Manual
Installation, Operation & Maintenance M
fgfgffhfgfggbffgfV11:0212212121
1)
of one section. O
of one section. Options
include supplied foam or a
include supplied foam or a
large bead of silicone around
large bead of silicone around
the entire inner perimeter of
the entire inner perimeter of
the aluminium frame, as
the aluminium frame, as
highlighted.
traps/chains, using the internal corner plates to
5)
roof, seal the gap between the
roof, seal the gap between the
sections with silicone before
sections with silicone before
the joining roof cap is fitted.
the joining roof cap is fitted.
Apply a seal to the face
Apply a seal to the face
If the AHU has a pitched
If the AHU