Bosch 800 Plus Series 빠른 시작 및 안전 매뉴얼 - 페이지 6
{카테고리_이름} Bosch 800 Plus Series에 대한 빠른 시작 및 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 800 Plus Series 13 페이지.
페이지 인쇄
5 Settings
5.1 Available Settings
Below are some commonly used settings. To see all the set-
tings refer to the full online manual or go to
Dishwasher » Settings in the Home Connect app.
Setting
r-Rinse Aid
r:00 - r:06
d-Intensive drying
d:00 - d:01
b-End of cycle tone
b:00 - b:03
rE-Factory reset
6 Frequently Asked Questions
Q:
Why is food remaining on dishes after I run the cycle?
•
It is possible the dishes do not have adequate clearance between them for the water to reach effectively. Also, be sure nothing
is blocking the spray arms and that the filter is clean. Select the Heavy cleaning cycle.
Q: Why does the cycle run a long time?
•
Sensors in the dishwasher automatically increase the cycle time to ensure a good wash when heavy soil is detected.
•
Incoming water may not be hot enough and dishwasher has to heat it.
Q:
Why is E:XX (X can be any number) displayed?
•
This is an error code. For example E:22 indicates there is water in the sump because the filter is blocked or needs clean-
ing. See the Use and Care Manual for a list of error codes or at this link:
https://www.bosch-home.com/us/owner-support/get-support/general-error-codes
Factory
Description
setting
r:05
Setting to adjust the
amount of rinse aid
used in each cycle.
d:00/ off
Setting to increase
drying ability for
glasses or plastic.
Increases cycle length
and temperature.
b:02
Setting for the volume
of the tone at the end
of the cycle.
rE
Restores the factory
settings on the dish-
washer.
5.2 Adjusting the settings
1. Press the power button.
2. Hold down button A sec to access the settings menu.
3. Press button A repeatedly to select the desired setting.
4. Press Start to change the value of the setting.
5. Press button A to save the setting.
Tip: The simplest way to change the settings is with the
Home Connect
®
app.