Bosch Apexx SHY99A 설치 지침 매뉴얼 - 페이지 13

{카테고리_이름} Bosch Apexx SHY99A에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Apexx SHY99A 34 페이지. Dishwasher
Bosch Apexx SHY99A에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (34 페이지), 설치 지침 매뉴얼 (21 페이지)

페이지 인쇄

E n g l i s h

PLUMBING PREPARATION

WARNING: SCALD HAZARD -

Serious injury could result if work is

performed on a charged hot water

line. Only qualified plumbers should

perform plumbing work. Do not

attempt any work on the dishwasher

hot water supply plumbing until you

are certain the hot water supply is

shut off.

CAUTION: Temperatures required for

soldering and sweating will damage

the dishwasher's base and water inlet

valve. If plumbing lines are to be

soldered or sweated, keep the heat

source at least 6 inches (152.4 mm)

away from the dishwasher's base and

water inlet valve.

Hot Water Supply

Bosh recommends that the hot water

heater be set to deliver approximately

120° F (49° C) water to the dish-

washer. Water that is too hot can

cause some detergents to loose

effectiveness. Lower water tempera-

tures will increase run times.

The hot water supply pressure must

be between 5 - 120 psi (0.3 - 8.27

bars).

Hot Water Supply Plumbing

NOTE: Regardless of where the hot

water supply line enters the enclosure

(following the guidelines on page 8),

position the line 14" (355mm) from the

14"

(355mm)

enclosure's left side, as shown in

Figure 7, letter A.

NOTE: Decide whether braided hose

or copper tubing will be used for the

hot water supply plumbing, and

purchase the correct type of hot water

supply shut-off valve, 90° elbow, and

Figure 7/Ilus. 7

necessary fittings for the hot water

supply plumbing.

Install an easily accessible shut-off valve

(not supplied) in the hot water supply

line, as shown in Figure 7, letter B.

All solder connections must be made

before the water line is connected to

the dishwasher's water inlet valve.

Water may also be supplied to the

dishwasher by using a braided hose

line. Check with your local plumbing

supply sources for the proper hose

and 90° elbow fitting.

(Continued on next page)

Plumbing Preparation | Plomberie | Preparación - Sistema Plomería