Bosch FAP-OC 500Series 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Bosch FAP-OC 500Series에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch FAP-OC 500Series 44 페이지. Built-in wall ovens
Bosch FAP-OC 500Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (21 페이지), 사용 설명서 지침 (40 페이지), 설치 매뉴얼 (6 페이지), 제품 정보 (40 페이지), 설치 매뉴얼 (28 페이지), 사용자 설명서 (48 페이지), 사용자 설명서 (48 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (32 페이지), 사용 및 관리 설명서/설치 지침 (40 페이지), 빠른 참조 매뉴얼 (4 페이지), 사용 및 관리 매뉴얼 (27 페이지), 설치 매뉴얼 (24 페이지), 설치 매뉴얼 (32 페이지), 사용 및 관리 매뉴얼 (24 페이지), 설치 매뉴얼 (28 페이지), 서비스 매뉴얼 (41 페이지), 사용 및 관리 매뉴얼 (21 페이지), 설치 매뉴얼 (32 페이지), 서비스 매뉴얼 (36 페이지), 설치 매뉴얼 (32 페이지), 빠른 시작 및 안전 매뉴얼 (13 페이지)

페이지 인쇄

Causes for damages

CAUTION

Risk of damage due to corrosion. Always turn

appliance on when cooking to avoid condensation

buildup. Condensation can lead to corrosion

damages.

Always replace blown bulbs immediately to avoid an

overload of the remaining bulbs.

Protecting the environment

Unpack the appliance and dispose of the packaging in

an environmentally friendly manner.

Operating modes

You can use this appliance in the air extraction or the

recirculation mode.

Exhaust air mode

The air that is drawn in is cleaned by

the grease filters and conveyed to the

exterior by a pipe system.

Note: Ventilation may not exit through an already

operational smoke or exhaust chimney, nor a duct used

for ventilating furnace installation areas.

If the ventilation is intended to pass through a smoke

▯

or exhaust chimney that is not in operation, the

responsible area heating inspector must give

approval.

If the ventilation passes through an external wall, use a

▯

telescope wall sleeve.

Risk of damage due to ingress of humidity into the

electronic circuitry. Never clean operator controls with a

wet cloth.

Surface damage due to incorrect cleaning. Clean

stainless steel surfaces in the grind direction only. Do not

use any stainless steel cleaners for operator controls.

Surface damage due to strong or abrasive cleaning

agents. Never use strong and abrasive cleaning agents.

Risk of damage from condensation back flow. Install

exhaust vent at a slight downward slope away from the

appliance (1° slope).

Circulating-air mode

The air that is drawn in is cleaned by the

grease filters and an activated carbon filter

and conveyed back into the kitchen.

Note: To bind odors in circulating-air mode, you must

install an activated carbon filter. The different options for

operating the appliance in circulating-air mode can be

found in the brochure. Alternatively, ask your dealer. The

required accessories are available for purchase from

specialist retailers, from Customer Service or from the

Online Shop. The accessory numbers can be found at

the end of the instructions for use.