Bosch SB Series 사용 설명서 - 페이지 30

{카테고리_이름} Bosch SB Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch SB Series 50 페이지. Dishwasher bosch
Bosch SB Series에 대해서도 마찬가지입니다: 사용 설명서 (38 페이지), 사용 설명서 (38 페이지), 사용 설명서 (42 페이지), 작동 지침 (36 페이지), 사용 설명서 (38 페이지), 사용 설명서 (48 페이지), 사용 설명서 (40 페이지), 사용 설명서 (44 페이지), 사용 설명서 (50 페이지), 사용 설명서 (44 페이지), 사용 설명서 (40 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지), 사용 설명서 (40 페이지), 사용 설명서 (46 페이지), 사용 설명서 (40 페이지), 사용 설명서 (46 페이지), 사용 설명서 (50 페이지), 사용 설명서 (48 페이지), 사용 설명서 (42 페이지), 사용 설명서 (40 페이지), 사용 설명서 (44 페이지), 사용 설명서 (42 페이지), 사용 설명서 (40 페이지), 사용 설명서 (40 페이지), 사용 설명서 (40 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (44 페이지), 사용 설명서 (44 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (50 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (48 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (50 페이지), 사용 설명서 (40 페이지), 사용 설명서 (42 페이지), 사용 설명서 (42 페이지), 사용 설명서 (48 페이지), 사용 설명서 (42 페이지), 사용 설명서 (40 페이지)

Bosch SB Series 사용 설명서
en Operating the appliance

Switching off the appliance

Shortly after the end of the
programme:
Switch off ON/OFF switch (.
1.
Turn off water supply (does not
2.
apply to appliances with Aqua-Stop).
Remove the utensils when they have
3.
cooled down.
About the Eco drying function:
When Eco drying is activated in the
Eco 50° programme, the door opens
automatically when the programme
ends. This ensures the best possible
drying result. Low amounts of steam
may occur. If you install the appliance
under a worktop, fit the supplied
steam protection film * (follow the
procedures in the installation
instructions). The steam protection film
protects sensitive fitted furniture and
worktops from damage by water
vapour. Before opening the appliance,
leave it to cool down for a while in the
remaining programmes when the
programme ends.
30

Interrupting the programme

Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
Switch off ON/OFF switch (.
1.
The LEDs go out. The programme is
saved.
Switch on the ON/OFF switch (
2.
again to continue the programme.

Terminating the programme

(Reset)
Press the START button P and
1 .
T e r m i n a t i n g t h e p r o g r a m m e
hold it down for about 3 seconds.
The value ‹:‹‚ appears in the
display window )". The
programme sequence lasts about
1 minute. The value ‹:‹‹ appears in
the display window )".
Switch off ON/OFF switch (.
2.