Bosch SGE63E06UC - Evolution 24" Special Application Dishwasher FR 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Bosch SGE63E06UC - Evolution 24" Special Application Dishwasher FR에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch SGE63E06UC - Evolution 24" Special Application Dishwasher FR 38 페이지. 24" recessed handle special application
Bosch SGE63E06UC - Evolution 24" Special Application Dishwasher FR에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (40 페이지), 보충제 (2 페이지), 설치 지침 매뉴얼 (39 페이지), 설치 지침 매뉴얼 (40 페이지), 사용 설명서 지침 (40 페이지), 브로셔 및 사양 (3 페이지)

Bosch SGE63E06UC - Evolution 24
WARNING
Make sure the water supply and electrical supply
are shut off before installation or service.
NOTE: This dishwasher is designed to be enclosed on the
top and both sides by standard residential kitchen cabinetry.
Select a location as close to the sink as possible for easy
access to water supply and drain lines.
For proper dishwasher operation and appearance, ensure
that the enclosure is square and has the dimensions shown
in Figure 1 below.
>23
/
" (600mm) use the TOP or SIDE MOUNT mounting
5
8
methods.
If the dishwasher is to be installed in a corner, make sure that
there is adequate clearance to open the door. See Figure
2 below.
Check clearance
between
dishwasher door
and wall
WARNING
Avoid Electrical Shock/Fire Hazard
Do not allow the electrical and water supply lines
6

Enclosure Requirements

90°
/
"(600mm)
5
8
Countertop
to touch.
After locating the proper place for your new dishwasher,
you will need to create any required openings to allow for
passage of the water, drain and electrical line. In order to
avoid interference with the dishwasher when sliding it into the
cabinet, place your openings within the dimensions shown
in Figure 3 below.
Required Openings:
4
/
" x 2
/
"
- To pass the included electrical supply
3
3
(120 x 60mm)
4
8
junction box through to adjacent cabinet.
Note: If the incoming electric supply, water supply and drain
connections are all in the same cabinet, the one 4
hole will be large enough for all three to pass
(120 x 60mm)
through.
4" x 2"
- To pass the included water supply line
(100 x 50mm)
toward the water supply
1
/
"
diameter - To pass the dishwasher drain hose
1
(32mm)
4
toward the drain connection
Before sliding the dishwasher into the cabinet, remove the
hose clip at the back of the dishwasher as shown in Figure
4. The hose clip may be used later to hold the drain hose as
shown in Figure 10.
In select models, remove the rubber apron on top of the
dishwasher and set aside for later use. See Figure 5.
Figure 5
Figure 3
4
1
/
"
2
(114mm)
1
2
/
"
2
/
" x 2
/
"
3
3
4
8
6