Bosch SGE63E06UC/55 설치 지침 매뉴얼 - 페이지 10
{카테고리_이름} Bosch SGE63E06UC/55에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch SGE63E06UC/55 37 페이지.
페이지 인쇄For a large port, use the drain hose as it is.
1.
For a small port, insert the rubber drain hose adaptor
into the drain hose end.
2.
Obtain the Rubber Drain Hose Adaptor (J) spring clamp
from the Dishwasher Installation Kit (do not substitute).
3.
Insert the dishwasher
drain hose into the end of the
drain hose (see Figure 15). Be sure to fully insert the
drain hose.
4.
Use the clamp provided to attach the Rubber Drain Hose
Adaptor to the house plumbing as shown in Figure 16.
Figure 15
Top Mount is used for countertops made of wood or other
materials that can be easily drilled. Orient the mounting
brackets as shown in Figure 17, and position the two small
tabs on the mounting brackets over the two slots on the dish-
washer's front corners. Push the mounting brackets down
firmly to insert the tabs into the slots.
©
Figure 16
Top Mount
Figure 17
Side Mount is used for countertops made of marble, granite,
or other very hard materials that cannot be easily drilled.
Bend the mounting brackets
along the small holes and in
the same direction as the two small tabs. Orient the mounting
brackets as shown in Figure 18, and position the two small
tabs on the mounting brackets over the two slots on the
dishwasher's
front corners.
Push the mounting
brackets
down firmly to insert the tabs into the slots. Bend perforated
edge down as shown.
Before installing the supplied
countertop
mounting
brackets,
decide
which
method
of securing
the
dishwasher
into its enclosure will be used. Once the
mounting
brackets are installed on the dishwasher,
removing
them
is difficult
and will
damage
the
mounting
brackets
and the dishwasher.
The dishwasher can be secured into its enclosure in 3 ways:
NOTE: If your dishwasher opening width measures >23%"
(600mm) use the TOP or SIDE MOUNT mounting methods.
If your dishwasher opening width measures 23%" (600mm)
use the ALTERNATE
SiDE MOUNT mounting method.
©
Side Mount
Figure 18
Alternate
Side Mount for opening 235/8" (600mm). Insert
a side mount force distributor (M) in each side as shown in
Figure 19.
Figure 19
Alternate Side Mount
10