Bosch SGS56E48EU 사용 설명서 - 페이지 19
{카테고리_이름} Bosch SGS56E48EU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch SGS56E48EU 28 페이지.
페이지 인쇄
Spray arms
Limescale and contaminants in the rinsing
water may block nozzles
and bearings on the spray arms 12
and 1B.
– Check outlet nozzles on the spray
arms for blockages.
– Unscrew the upper spray arm 12.
– Remove the lower spray arm 1B
upwards.
– Clean spray arms under running water.
– Re-engage or screw on spray arms.
Troubleshooting
The majority of faults which could occur in
daily operation can be rectified by the
user. This ensures that the appliance is
quickly available for use again. The
following overview will help you locating
the causes and gives helpful advise to
eliminate them.
Note
If the appliance stops during dishwashing
for no obvious reason, first run the Abort
programme function (Reset).
(See chapter entitled "Basic functions")
ã=
Warning
Don't forget: Repairs may be carried out
by technicians only. If a component has to
be replaced, ensure that only original
spare parts are used. Improper repairs or
use of non-original spare parts may cause
considerable damage and put the user at
considerable risk.
Waste water pump
Large food remnants in the rinsing water
not retained by the filters may block
the waste water pump. The rinsing water
is then not pumped out and covers
the filter.
In this case:
– First disconnect the appliance from
the power supply.
– Remove the bottom basket.
– Remove the filters 1b.
(See chapter entitled Maintenance
and care)
– Scoop out water, use a sponge if
required.
en
19