Dragon Touch E40 사용자 설명서 - 페이지 4

{카테고리_이름} Dragon Touch E40에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dragon Touch E40 8 페이지.

Antenna

Battery Compartment Cover

Reset Button

Note: The charging LED indicator is red while charging. When the red light turns oﬀ

or turns blue, it indicates that the battery is fully charged.

GETTING STARTED

1. Powering the Camera Unit

① Connect the camera power adapter to the camera unit.

② Place the camera unit at least 3 feet away from your baby's crib. Make sure the

power cord is out of reach of your baby.

Tips: The mount kit included in the package allows you to mount your the camera

on a wall, ceiling or simply place it on a table.

MIC

Speaker

Micro USB Port

Microphone

2. Charging and Powering the Monitor Unit

For the best results, charge the monitor unit before use. After the initial charge,

recharge normally as required. The monitor unit works normally with the power

adapter plugged into the unit.

① Plug the USB power adapter into an electrical outlet. Connect the USB cable to

the micro-USB of the monitor unit.

② Press and hold the Power/Sleep button for 2 seconds to turn on the monitor unit.

The power LED indicator will turn blue to indicate the unit is ON.

③ Once both the camera and monitor are switched on, the video captured by the

camera will be displayed on the monitor unit.

④ If there is no connection or the camera is out of range, the monitor will go oﬀ and

beep. Move the monitor closer to the camera until the link is re-established.

Note: The battery icon turns red on the LCD screen to indicate that the battery is

low, and it gives a beep periodically.

3. Pairing a New Camera Unit

The camera unit and monitor unit provided are already paired. You do not need to

pair it again unless the camera unit loses its link with the monitor unit. To re-pair

your camera unit, or pair a new camera unit, follow the procedures below:

① Press Menu button of the Monitor Unit choose the cam icon "

4:00

3:00

2:00

1:00

0:00

OFF

10:44AM