AirStage AGHA007GCAH 설치 매뉴얼 - 페이지 15
{카테고리_이름} AirStage AGHA007GCAH에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage AGHA007GCAH 15 페이지. Indoor unit (floor type)
AirStage AGHA007GCAH에 대해서도 마찬가지입니다: 운영 매뉴얼 (8 페이지)
페이지 인쇄
10. ERROR CODES
If you use a wired type remote controller, error codes will appear on the remote controller
display. If you use a wireless remote controller, the lamp on the photodetector unit will
output error codes by way of blinking patterns. See the lamp blinking patterns and error
codes in the table below.
Error indications
OPERATION
TIMER lamp
FILTER lamp
lamp (green)
(orange)
(red)
(1)
(2)
(1)
(4)
(1)
(6)
(2)
(6)
(2)
(9)
(3)
(1)
(5)
(1)
(3)
(10)
(4)
(1)
(4)
(2)
(5)
(1)
(5)
(2)
(5)
(3)
(5)
(4)
(9)
(15)
(10)
(8)
(13)
(1)
Display mode
: 0.5 s ON / 0.5 s OFF
: 0.1 s ON / 0.1 s OFF
( ) : Number of flashing
Wired Remote
Controller Error
Error contents
code
Remote controller com-
munication error
Network communica-
tion error
Peripheral unit com-
munication error
Indoor unit address
setting error
Connection unit
number error in wired
remote controller
system
Indoor unit power sup-
ply abnormal
Indoor unit main PCB
error
Indoor unit commu-
nication circuit (wired
remote controller) error
Indoor unit room temp.
thermistor error
Indoor unit heat ex.
temp. thermistor error
Indoor unit fan motor
1 error
Indoor unit coil (expan-
sion valve) error
Indoor unit water drain
abnormal
Dumper error
Outdoor unit miscel-
laneous error
Poor refrigerant circula-
tion
RB unit error
Wired Remote Controller Display
UTY-RNR*Z2 (2-wire type)
Error icon
Touch the [Status].
Touch the [Error Information].
2-digit numbers are corresponding to
the error code in the preceding table.
For more information, refer to the installation manual of the remote controller.
UTY-RLR* (2-wire type)
Error icon
For more information, refer to the installation manual of the remote controller.
Touch the [Next Page] (or [previous page])
to switch to other indoor unit information.
Error code
En-14