Dragonfly DFRM-TAB-100-MW 설치 매뉴얼 - 페이지 3

{카테고리_이름} Dragonfly DFRM-TAB-100-MW에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dragonfly DFRM-TAB-100-MW 9 페이지. Recessed in-ceiling motorized projection screen
Dragonfly DFRM-TAB-100-MW에 대해서도 마찬가지입니다: 설치 매뉴얼 (17 페이지)

페이지 인쇄

Installation

Caution: Make sure the ceiling structure can support the screen's weight. Screen weights are

listed in "Assembled Weights" on page 14.

Note:

The screen cannot be removed from the housing.

Step 1. Determine the Mounting Method

Z Brackets

• Z Brackets: Used for all installations with new or existing permanent ceilings and when there is no

access above the screen housing such as an attic or a crawl space.

• Flat Brackets: Used for installations with new ceiling and access above the screen at all times,

such as a commercial tile ceiling, an attic, or a crawl space.

Step 2. Prepare the Ceiling Opening

Screen Housing Cutout

Use the chart to determine the opening size for the housing, then cut the ceiling surface.

Type & Size

Length (A)

Width (B)

TAB-100"

113.51"

7.25"

TAB-110"

122.21"

7.25"

TAB-120"

130.91"

7.25"

TAB-130"

139.65"

7.25"

NTT-100"

104.06"

7.25"

NTT-110"

112.76"

7.25"

NTT-120"

121.46"

7.25"

NTT-130"

130.20"

7.25"

Height Clearance (C)

Dimensions measured from bottom of ceiling surface to top of screen housing including the height of

mounting bracket and hardware.

7.0"

Flat Brackets

7.25"

Step 3. Install the Mounting Brackets

The mounting brackets are secured using hardware that slots into the

rails on top of the housing. Slide the bolts into the rail, position the

brackets over the bolts, and tighten the nuts onto the bolts.

Z Bracket Suspended Mounting

Install the brackets facing down for threaded rod/

suspended mounting or up for direct ceiling

mounting.

Z Bracket Direct to the Ceiling

Install the brackets facing up when mounting directly to the ceiling. Position the

bend in the bracket flush with the edge of the screen housing.

Straight Bracket Installation

Install the brackets a minimum distance apart to prevent instability after hanging the screen housing.

The brackets may be positioned off-centered as needed to fit the ceiling structure.

Size

Minimum Bracket Separation

100"

74"

110"

80"

120"

85"

130"

90"