Dragonfly FM-NTT-GR 설치 매뉴얼 - 페이지 6

{카테고리_이름} Dragonfly FM-NTT-GR에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dragonfly FM-NTT-GR 17 페이지. Motorized tab-tension

DFM-TAB Installation Manual

5. Installation

The mounting brackets can be attached anywhere on the screen housing, but they should be about 4" from

each end to ensure that vibration or noise is prevented during operation.

1. Measure the width of the Projector Screen Housing (Dim. "B" in Section 12. Dimensions and Weight) and

subtract 8" to estimate the distance the brackets should be mounted apart.

2. Mark the location of one bracket on the mounting surface, then measure to the planned location of the second

bracket. Adjust the general location of each bracket to allow for both to mount securely to wood or concrete.

Be sure that wall-mounted brackets are level before installation.

3. Mark the screw holes for each bracket and install them:

Mounting to Wood Joists or Studs

Use the included mounting screws to secure the projector

mount brackets to the surface.

•

No pre-drilling is necessary for most applications.

•

Use 4 of the 8 included screws to mount each bracket

as pictured.

Warning!

larger than a 5/32" bit. Larger holes will not

properly grip the threads, and the projection

screen could fall.

Mounting to Concrete Ceiling or Wall

Use the included anchors for the mounting holes and install

the screws into the anchors.

•

Use a 7/32" masonry bit to drill a hole for each screw.

•

Insert the anchors into the holes until they are flush.

•

Do not install anchors into mortar joints.

•

Use 4 of the 8 included screws to mount each bracket

as pictured.

Pg. 6

Top of Brackets Must Be Level

Top of Screen Housing Will Be Here

Approximate Distance = Screen Housing Width Minus 8"

If holes are pre-drilled, use no

Wall Mount

Ceiling Mount

Wall Mount

Ceiling Mount