Advanced Elements AdvancedFrame AE1012 소유자 매뉴얼 - 페이지 13
{카테고리_이름} Advanced Elements AdvancedFrame AE1012에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Advanced Elements AdvancedFrame AE1012 20 페이지. 1 person kayak
Advanced Elements AdvancedFrame AE1012에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (19 페이지)
페이지 인쇄
ALWAYS practice safety and take the time to learn about the area where you are paddling. Get
you do not over estimate your strength, your endurance or your skill. Be careful never to under
estimate weather conditions. Be aware of the dangers before you begin. Be aware of your skill
level. Be sure you understand and accept the risk of these dangers. There are many paddling
clubs all over the world. These can be a great source of information on places to paddle, people
to paddle with and most importantly, continued safety practices.
5. PROPER CARE AND STORAGE
use and care will increase the life of your kayak. Before storing your kayak, make sure it is both
CLEAN and DRY. You may clean your kayak with a mild soap and water. NEVER use strong
solvents to clean your kayak as they will destroy the material.
kept out of direct sunlight when stored. Avoid exposure to extreme temperatures (hot or cold).
If your boat is exposed to freezing temperatures while storing, allow it to warm up before
unfolding.
Do not store your kayak for an extended period of time while wet.
Follow these steps for removing excess water.
1. Unzip the 2 zippers that run down the center of the kayak.
2.
from the outer cover. In order to completely separate these parts, it is necessary to
unscrew the locking nut on the spring valve.
3. Use a sponge or towel and wipe up any excess water in the outer cover.
4.
5. If there is sand or gravel in the kayak, you can hose out the cover, and then wipe it
down with a towel.
6.
kayak absorbing most of the water, then pack it up.
6. REPAIRS
All kayaks come with a repair kit that includes glue and several patches. This should remain
with the kayak in the event that you may need it. If service is required for your kayak, please call
866-262-9076 for assistance.
6.1 Repairing Small Punctures and Cuts
1. Cut a rounded patch at least ¼" or ½" larger than the hole or cut.
2. Clean the area where the patch will be placed with water and/or mild soap.
3. Make sure all surfaces are dry.
4. In a well ventilated area, spread a thin layer of glue on both the patch and on the
®
13