Electrolux WRT18MP6CS 사용 및 관리 매뉴얼 - 페이지 6
{카테고리_이름} Electrolux WRT18MP6CS에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux WRT18MP6CS 18 페이지. Top mount refrigerator
페이지 인쇄Door
Stop
Handle
Tools Necessary:
Hinge
Screw
Screw
Phillips"
head
or
Quadrex
head
screwdriver
Socket
Adjustable
Wrench
Set
Wrench
Awl
DOOR REMOVAL AND REVERSAL INSTRUCTIONS:
Cabinet
Hole
Plugs
Hinge
HoUe
Hole
1.
Remove toe grille.
2.
Remove top hinge with 3/8" hex driver and lift freezer door off of center
hinge pin. Set door aside.
3.
Unscrew center hinge pin using adjustable wrench and save for
reassembly. Ensure plastic washer stays on hinge pin.
4.
Lift refrigerator door off of bottom hinge and set aside.
5.
Remove center hinge and shim by removing inside screw and
loosening two outside screws enough to allow hinge and shim to slide out.
Tighten screws.
6.
Loosen two outside screws on opposite side of refrigerator,
remove inside
screw and install center hinge.
7.
Remove two screws on bottom hinge with 3/8" socket wrench.
8.
Install bottom hinge on opposite side with the two screws removed from
step 7.
9.
Unscrew bottom hinge pin using adjustable wrench. Move hinge pin to
other hole in hinge and tighten with adiustabIe wrench.
10. Reverse door handles (see instructions
on next page).
11. Move freezer and refrigerator door stops to opposite side. Before starting
screws, use an awl to puncture the foam.
12. Position refrigerator door onto bottom hinge pin and screw center hinge pin
through center hinge into top of door. Close refrigerator door to help align
hinge hole.
13. Tighten center hinge pin with adjustable wrench.
14. Remove cabinet and hinge hole plugs and move to opposite side.
15. Lower freezer door onto center hinge pin.
16. Close freezer door. Have an assistant lift up on opposite side of door while
tightening screws to install top hinge.
17. Replace toe grille.
18. Plug in electrical power cord and turn refrigerator temperature
control to
center position. Adjust setting as necessary.