Drainvac ProXtrak DV2P57 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Drainvac ProXtrak DV2P57에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drainvac ProXtrak DV2P57 12 페이지. Liquid extractor proxtrak series

APPLICATION

Begin work from the closest point to the unit "X", right or left. Progress away from the

unit and add hose lengths as required. When the farthest point is reached, work back

towards the unit removing excess hose lengths as you progress back towards the unit.

Using this method will keep hoses out of the way. For better hose drainage, lift hose

end and keep it elevated as you walk back towards the joint of the hose to be removed.

Once you have finished, rince the vacuum hose with clean water by vacuuming water

from a filled sink until unit has filled up and dumped once. While rinsing do not immerge

the hose completely. Allow some air in.

Let unit run for 1 to 2 minutes to dry out the accessories and the hose.

Stop unit and leave it in position to let it drip.

After storing the accessories and the hose remove the unit. To avoid dripping on the

floor, carry the unit horizontally by tilting it towards you.

Figure A

The liquid extractor is a plug-in type. Some have up to two (2) motors and each motor

has its own electrical plug-in cord.

Each motor must be plugged to a separate circuit to prevent breaker overload and

power interruption.

DIAGRAMS OF THE APPROPRIATE CONNECTIONS

FOR YOUR MODEL

Electrical Panel

DV2P56: 15 amp. circuit / 120V

Electrical Panel

DF2P56: 16 amp. circuit / 240V

DV2P57: 5 amp. circuit / 120V

DF2P57: 16 amp. circuit / 240V

DV2P552: 15 amp. circuit / 120V

DF2P552: 16 amp. circuit / 240V