DRAKE MMTS20 매뉴얼 - 페이지 3
{카테고리_이름} DRAKE MMTS20에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DRAKE MMTS20 4 페이지. Stereo encoder
페이지 인쇄6
INSTALLATION - AUDIO LEVEL SETTING, continued
4) Set the MMTS20 'TEST TONE' switch to the
'OFF' position. Connect Left and Right audio
source signals to the MMTS20.
5) Set the 'Audio LEVEL' control on the
MMTS20 to a point where the
'OVERMODULATION' indicator just remains off
or flashes occasionally.
METHOD 2: (If a spectrum analyzer is not
available).
1) Connect the MMTS20, A/V modulator,
compatible DC power source, and video source
signal as shown on this page. Keep the 'TEST
TONE' switch 'OFF' for this procedure.
2) Connect a TV receiver (with MTS stereo
capability) to the A/V modulator. Tune the TV
receiver to the same channel as the modulator
output.
NOTE: Make certain that the audio response of
the A/V modulator is set for 'FLAT'
(pre-emphasis defeated).
Video Source
MMTS20
Video Input
Loop-Through
STEREO
ENCODER
POWER
Composite
PILOT
Audio Out
LOCK
ON
TEST
TONE
OFF
DC Input
OVER-
MOD
Audio
AUDIO LEVEL
In
MMTS20 FRONT
MMTS20 REAR
Right audio source
Left audio source
(250 mV rms to 2.5 V rms)
The system audio levels are now properly set.
Disconnect the test equipment.
3) Connect the audio source signal (not a tone)
to either the LEFT or the RIGHT Audio Input of
the MMTS20.
4) Set the 'Audio LEVEL' control on the
MMTS20 to a point where the
'OVERMODULATION' indicator just remains off
or flashes occasionally.
5) While monitoring the opposite audio channel
from the TV receiver audio output, set the
'Audio' level control on the A/V modulator for a
maximum (stereo) separation condition.
Video Input
Audio
Cable
Audio Input
DC Input
To
System Distribu-
tion
or
TV Receiver
A/V MODULATOR
REAR PANEL CONNECTIONS / INTERNAL JUMPERS
R1
R2
R3
R4
R1 - VIDEO INPUT Connector
This is the baseband video input to the
MMTS20 which provides the encoder circuitry
with the modulator horizontal sync information.
The baseband video to the modulator must be
'looped through' this input using an external 'F'
type Tee (T) connector.
R2 - COMPOSITE AUDIO OUT Connector
This is the unbalanced composite BTSC format
stereo signal output. The output from this RCA
phono receptacle must be connected to the
AUDIO INPUT of the modulator. The connected
modulator audio response must be set for 'Flat'
(pre-emphasis defeated).
Figure 2
R3 - DC INPUT Connector
This 3-pin connector (Male) accepts the
appropriate mating DC power cable. Observe
proper orientation and wiring.
R4 - LEFT AUDIO INPUT/RIGHT AUDIO
INPUT Connectors
These are the left and right audio source input
connectors that accept either a balanced or
unbalanced configuration. Use the Tip (+) and
Ring (-) of a mating male 3.5 mm 'stereo' plug
for a balanced connection. If an unbalanced
input is required, the Ring (-) contact should be
connected to ground (shield) with the audio hot
connected to the Tip (+).
3