Drake Systems SP-1001R 사용 설명서 - 페이지 3
{카테고리_이름} Drake Systems SP-1001R에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Drake Systems SP-1001R 10 페이지.
페이지 인쇄•The receiver enters into the change of MODE with beep tone
when the
MODE KEY is pressed for more then 2 seconds.
•The procedure for the change of MODE is as follows.
• RF RECEIVING ON/OFF
• SELECT OF ALERT TONE or VIBRATION
• ADJUST OF CLOCK
• WAKE-UP ALARM ON/OFF
• ADJUST OF WAKE-UP ALARM TIME
•The left button will be used when the change of MODE is
required.
•When the MODE-KEY is usually pressed shortly, the MODE-
KEY is used
for the display of previous status or reset of current
status.
1-2-5.
THE USAGE OF PARKING TIMER
•The receiver enters into change of PARKING TIMER with beep
tone when
the left button is pressed for more then 2 seconds. At
that time, the
clock on the LCD will blank which enables the change of
PARKING TIMER.
•At this mode, the left button is used to increase the hour
or minute
when the icon is blanking and the right button is used to
move the
blinking icon to the right.
•The icon of PARKING TIMER is blanking when the PARKING
TIMER is being
operated The operation of PARKING TIMER is cancelled when
the left
button is pressed for more then 2 seconds during the
operation of
PARKING TIMER.
•The previous PARKING TIMER is memorized in the memory of
the receiver.
when you press the left button
for more than 2 seconds.
1-2-6.
THE EXCHANGE OF BATTERY
•Please
within 2 days
when the icon of low battery on the LCD is turned on.
•The
receiver
PARKING TIME and
ID into the memory of the receiver, but it does not
memorize the
CURRENT TIME. When the battery is exchanged with new
battery, you should re-adjust your clock on the receiver.
The current time will be set to 12:00 when you change the
battery.
You can use the previous PARKING TIMER
exchange
the
memorizes
current
battery
the
CURRENT
with
new
battery
MODE,
ALARM
TIME,