AirStage ARXK18GALH 설치 매뉴얼 - 페이지 15
{카테고리_이름} AirStage ARXK18GALH에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage ARXK18GALH 19 페이지. Indoor unit (duct type)
페이지 인쇄
6.7. IR receiver unit (Optional parts)
• For the installation method, please refer to the INSTALLATION MANUAL of IR receiver
unit.
Connection method
• Connection terminals
Controller PCB
• Wiring arrangement
Controller PCB
• Use 7 pins for receiver unit cable.
• At fi rst, connect the receiver unit cable to the controller PCB.
• Attach the core that comes between controller PCB and the clamp.
• Use conduit hole when external output cable is used.
To protect the cable insulation after opening a knockout hole, remove any burrs from
the edge of the hole.
6.8. Auto louver grille (Optional parts)
Connection method
• Connection terminals
Controller PCB
IR receiver
unit terminal
(CN18)
Core
CAUTION
Auto louver
grille terminal
(CN12)
• Wiring arrangement
Controller PCB
To protect the cable insulation after opening a knockout hole, remove any burrs from
the edge of the hole.
6.9. Optional parts cable binding
Power supply
cable
Avoid touching the ceiling with the wiring
Ceiling
Do not bind the power supply cable and other cables together.
To protect the cable insulation after opening a knockout hole, remove any burrs from
the edge of the hole.
CAUTION
Cable tie (Medium/Accessories)
Remote sensor, Receiver unit
and Auto Louver grille
Cable tie (Medium/Accessories)
External input and external
output
Avoid covering the air inlet
with the wiring.
CAUTION
En-14