Bosch 300 Series 사용 및 관리 설명서/설치 지침 - 페이지 17

{카테고리_이름} Bosch 300 Series에 대한 사용 및 관리 설명서/설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 300 Series 40 페이지. Built-in wall ovens
Bosch 300 Series에 대해서도 마찬가지입니다: 사용 설명서 지침 (40 페이지), 사용자 설명서 (21 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (36 페이지), 설치 매뉴얼 (32 페이지), 사용 설명서 (50 페이지), 빠른 시작 및 안전 매뉴얼 (7 페이지), 설치 매뉴얼 (28 페이지), 빠른 시작 매뉴얼 (7 페이지), 사용 및 관리 매뉴얼 (32 페이지), 빠른 시작 및 안전 매뉴얼 (7 페이지), 서비스 매뉴얼 (36 페이지), 빠른 시작 및 안전 매뉴얼 (13 페이지)

Bosch 300 Series 사용 및 관리 설명서/설치 지침

Leveling the dryer

Importance of leveling the dryer
It is important that your dryer is level and that all four
dryer feet press with equal pressure against the floor.
This will help assure the quietest, most vibration-free use
of your dryer.
To adjust the dryer feet:
Install the dryer on a level and solid surface, preferably
1.
in a corner of a room.
If the floor is uneven (or not level) adjust the dryer feet
2.
as required to level the dryer. Do not place anything
under the dryer feet to help level the dryer.
Extend the dryer feet no more than is necessary. The
3.
more the feet are extended, the more vibration the
dryer will experience. Start with the dryer feet turned all
the way in and adjust each foot as necessary.
Use a bubble level to check the top of the dryer to
4.
make sure it is level side to side and front to rear.
Press down on each corner of the dryer top to make
5.
sure the dryer does not "wobble". There should be no
"give" or movement. All four dryer feet should press
equally against the floor. This is just as important as
the dryer being level to prevent vibration.

Check heating system

Check that the drum is empty.
1.
Close the dryer door.
2.
Switch the dryer to Cotton Extra Dry and then touch
3.
the Start/Pause button.
After 2-3 minutes touch the Start/Pause button and
4.
open the door.
If the interior of the dryer feels warm, the dryer has
been connected properly. Switch the dryer to Off.
If the dryer does not work, switch the dryer to Off.
Look in the Troubleshooting section of this user
manual for hints in solving the problem.
Preparing to transport the dryer - step by
step
Rotate the program selector to Off.
1.
Pull out power supply plug.
2.
Place any accessories in the drum.
3.
Close the door and secure with adhesive tape.
4.
Screw the height-adjustable feet of the dryer into the
5.
housing to prevent them from being damaged during
transportation.
17