Bosch Axxis WFL 2090 작동, 관리 및 설치 지침 매뉴얼 - 페이지 9
{카테고리_이름} Bosch Axxis WFL 2090에 대한 작동, 관리 및 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Axxis WFL 2090 36 페이지. Axxis lavadora
Bosch Axxis WFL 2090에 대해서도 마찬가지입니다: 작동 및 관리 지침 매뉴얼 (37 페이지), 작동 및 설치 지침 (37 페이지), 작동, 관리 및 설치 지침 매뉴얼 (36 페이지), (영어) 사용 설명서 (37 페이지)
페이지 인쇄
About Your Washing
Machine
Using For the First
Time
The washing machine offers the following standard
features:
Horizontal-Axis,
Tumble Action Wash System,
without agitator
Stainless Steel Inner Wash Drum
-
Exceptionally
Low Energy and Water
Consumption
-
Internal Heating Element
for Power temp.
boost, up to 160 °F (71 °C)
-
High Spin Speeds, up to 1000 rpm, remove
more water from fabrics to reduce drying time
and energy
-
4 Fabrics and 5 Temperature
Settings
-
3 special cycles
-
3 additional functions
Before Usin
F rst Time
For the
The washing machine must have been installed
and connected
properly (refer to page 26).
Before beginning to use your washing machine for
the first time:
_3
_3
Make sure the voltage the washing machine
is to operate on is the same as shown on the
rating plate.
Check to make sure that the water valves to the
washing machine are open.
Your appliance was tested before leaving the
factory. To remove any water left over from testing
procedures,
the first washing cycle should be
carried out without laundry in the machine.
_3
_3
_3
_3
_3
_3
_3
_3
_3
%
Do not load any laundry.
Turn on the water tap.
Open the detergent
dispenser to the final stop.
Pour approx.
1 liter/1 quart of water into
chamber
II of the detergent
dispenser.
Fill the measuring cup half full with detergent
and pour into chamber
II. Do not use any
special detergents
for delicates or wool (to
avoid excessive foaming in the absence of
clothing in the wash).
Close the detergent
dispenser.
Close the loading door.
Set the program selector to Power
temp.
boost.
The ready control light is flashing.
Press the Start
button.
The wash control light comes on and the
program
starts.
door locked
illuminates while the program is
running.
The wash control light changes during the
program to rinse/spin.
When the finished
flashes:
Set the program selector to Off.