Exterior Motorized FlexShade
Section 1 - Preparation for Installation
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
MOUNTING
1 "
BRACKET
(44 mm)
E N
D C
A P
Figure 1
Section 2 - Mounting Headbox with Brackets
Section 2.1 - Wall Installation
Caution: Mounting Brackets
required for proper spacing of unit
off the wall for Side Channel
alignment.
1
Figure 3-A
Section 2.2 - Ceiling Installation
1. Attach Mounting Brackets to ceiling using #10 flat head
screws installed flush with bracket.
Please Note: USE ALL FOUR
(4)
1
Figure 3-B
1. Ensure mounting surface is strong enough to hold the Exterior Motorized FlexShade
2. Verify unit measurements and make sure it will fit in the desired location.
Please Note: Hem Bar does not retract into
the Headbox and must be accounted for if
mounting over a swinging window or door.
3. Mounting Brackets MUST be installed with a
gap of 1 3/4"
between the Endcap and
(44mm)
the Mounting Bracket edge
jamb, or ceiling.
4. Drill small starter holes
mounting surface.
5. Determine which headbox style is being
used
.
(Fig. 2)
1. Attach Mounting Brackets to the wall using #10 flat
head screws installed flush with bracket.
Please Note: Be sure to use AT LEAST 2 of the top
mounting holes
2
2. Attach Headbox to brackets and tighten Set Screws
3. Mount the Side Channels
mounting holes
.
(Fig. 3-B)
2
®
. Mark wall,
(Fig. 1)
Square
Headbox
in
(if necessary)
.
(Fig. 3-A)
3
(Section 3)
3
.
®
Figure 2
HEADBOX STYLES
3 "
(92mm)
3 "
(92mm)
2. Attach Headbox to brackets and tighten
Set Screws
(Fig. 3-A)
3. Mount the Side Channels
4
Tighten Set Screws
.
(Fig. 3-B)
or install Cable Guides
(Section 4)
4
Tighten Set Screws
page 3 of 12
3 "
(92mm)
Cur
Hea
.
.
(Section 3)
.
페이지 인쇄