Draper Nocturne 설치 지침 - 페이지 2

{카테고리_이름} Draper Nocturne에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper Nocturne 4 페이지. Draper nocturne exterior projection screen

페이지 인쇄

Nocturne Exterior Projection Screen by Draper

Nocturne Exterior Projection Screen—Crank and Motorized Dimensions

Total width = Viewing Surface width + 3

Figure 5

www.draperinc.com

Electrical Connections

Screen operates on 110-120V, 60 Hz. current. Screen is shipped with internal

wiring complete and control switch (es) fully boxed, and supplied with a 6'

cable lead. Longer lead can be substituted by removing two screws in motor

end of roller, removing lead, plugging new lead in, and replacing screws. Wire

to connect shade to switch (es) and switch (es) to power supply should be fur-

nished by installer. Con nec tions should be made in ac cor dance with attached

wiring diagram, and wiring should comply with national and local electrical

codes. DO NOT wire motors in parallel without written permission from

Draper.

All operating switches should be "off" before power is connected.

Limit Switch Adjustments—Standard Motor

Please Note: Screen limits are factory set for optimum performance of

the screen. A procedure is outlined below for minor tweaks, but any ad-

justment of these limits may negatively affect the ﬂ atness of the screen

surface and could also void the warranty. Please check with Draper prior

to resetting screen limits.

CAUTION: Always be prepared to shut screen off manually when new

adjustment is being tested. Screen may be severely damaged if viewing

surface is allowed to run too far up or too far down.

CAUTION: Be sure all switches are in "off" position before ad just ing

limit switches.

Push Button Limits

① Fully depress both limit switch push buttons, then operate wall

switch to make sure system works properly.

② Raise screen to desired "up" stop position.

③ Set upper limit by depressing and releasing the proper (back)

push button.

④ Lower screen to desired "down" stop position.

⑤ Set lower limit by depressing and releasing the proper (front)

push button.

Screw-Type Limits

① Determine which direction of travel corresponds with arrows on

motor.

② Operate screen to desired "down" stop position. Set limit by

turning the proper socket toward the "+" to lower the limit, and

"-" to raise it.

③ Operate screen to desired "up" stopping position. Set limit by

turning the proper screw toward the "-" to raise the limit, and "+"

to lower it.

(765) 987-7999

Page 2 of 4

Back

½"

Motor End

1½"

Top