Bosch WA SERIES 사용 설명서 및 설치 지침 - 페이지 23

{카테고리_이름} Bosch WA SERIES에 대한 사용 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WA SERIES 32 페이지. Washing machine

페이지 인쇄

Faults and what to do about them.

Faults

Water is leaking out.

Water not flowing in.

Detergent is not dis-

pensed.

Washing machine door

cannot be opened.

Programme does not

start.

Detergent solution is not

drained.

Water not visible in the

drum.

The spin result is not sat-

isfactory.

Laundry wet/too damp.

Spin cycle activated sev-

eral times.

The programme takes

longer than usual.

The programme duration

changes during the wash

cycle.

Residual water in the care

product compartment.

Odours in the washing

machine.

x symbol flashes. Foam

may escape from the

detergent drawer.

Cause/remedial action

Attach/replace the drain hose correctly.

■

Tighten the screw connection on the supply hose.

■

Start button not pressed?

■

Tap not open?

■

Filter blocked? Clean the filter

■

Supply hose kinked or trapped?

■

Safety function active. Stop programme?

■

$ Rinse hold = 2 without final spin selected?

■

Can be opened by emergency release only?

■

Start button for a pause or Ready in time pressed?

■

Washing machine door closed?

■

Childproof lock active? Deactivate.

■

$ Rinse hold = 2 without final spin selected?

■

Clean the drain pump.

■

Clean the waste pipe and/or drain hose.

■

Not a fault – water below the visible area.

Not a fault – the unbalanced load detection system has interrupted the spin

■

because the laundry is unevenly distributed. Distribute small and large

items of laundry in the drum.

Selected speed too low?

■

Not a fault – the unbalanced-load detection system is adjusting the imbalance.

Not a fault – unbalanced load detection system adjusts imbalance by

■

repeatedly distributing the laundry.

Not a fault – foam detection system active – a rinse cycle is switched on.

■

Not a fault – the programme sequence is optimised for the specific washing

process. This may result in changes to the programme duration in the display

field.

Not a fault – the effect of the care product is not affected.

■

Clean the insert if necessary.

■

Run the Cottons 90 °C programme without laundry. Use standard detergent for

this.

Too much detergent used?

Mix one tablespoonful of fabric softener with ½ litre water and pour into com-

partment II (Not for outdoor fabrics, sportswear fabrics or those made with

down.)

Reduce detergent dosage for the next wash cycle.

Faults and what to do about them.