Draper Series V 설치 및 운영 지침 - 페이지 4
{카테고리_이름} Draper Series V에 대한 설치 및 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper Series V 4 페이지. 220v silhouette/series e & v electric projection screen
Draper Series V에 대해서도 마찬가지입니다: 설치 및 운영 지침 (4 페이지)
페이지 인쇄220V Silhouette/Series E & V by Draper
121
mm
Series E Viewing Surface Shown; Series V with Tab Tensioning also available.
At left, Series V slat bar is depicted inside case. Series E has a typical round bottom dowel. For
all Silhouettes, the dowel is concealed inside the case.
Single Station Control
CE Approved
Terminal strip in
junction box at left
end of screen
Control
switch
Dashed wiring
by electrician
Low Voltage & Wireless Control
Case Dimensions
Silhouette
D
152
Series E
13.5 cm
mm
Series V
Varies
Wiring Diagram
Multiple Station Control
230V,
PE
50 Hz.
Red-to screen (directional)
Brown-to screen (directional)
White-Common to screen, 230V AC
Black-to 230V AC
Yellow-to 230V AC
Green-Ground
Dashed wiring by electrician
Low voltage wiring by others
Eye Port for IR Eye, RF Receiver or LED
Switch For more than one of these,
a splitter is required.
3 Button Wall Switch
DOWN - Black
COM - White
UP - Red
Aux Port for connecting additional
LVC-III modules (up to six total-
connect from Aux to Eye).
www.draperinc.com
22 mm holes for supply wires located on back
and top, 64 mm from left end of case.
D
Viewing Surface
Not CE Approved
Terminal strip in
junction box at left
end of screen
Cap off with wire
nut & tape
Blue
Red
Black
Red
Blue
Black
Blue
Red
Black
Dashed wiring
by electrician
230V, 50 Hz.
Terminal strip in
junction box at left
end of screen
All-Pole Disconnect
by Others
STOP
STOP
230V, 50 Hz.
Control
Switches
24v DC
(765) 987-7999
Page 4 of 4
MC1
See separate Serial Communica-
tion-RS232 Instruction sheet for
enabling RS232 with the MC1.