Bosch WAE12060SG 사용 설명서 - 페이지 2
{카테고리_이름} Bosch WAE12060SG에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WAE12060SG 8 페이지.
Bosch WAE12060SG에 대해서도 마찬가지입니다: 기능 및 사양 (20 페이지)
페이지 인쇄
Risk of electric shock!
Care
Maintenance
Pull out the mains plug!
Risk of explosion! No solvents!
Machine housing, control panel
- Wipe with a soft, damp cloth.
- Do not use abrasive detergents.
1.
- Immediately remove washing and cleaning agent residue.
- Do not clean the appliance with a water jet.
Clean the detergent drawer ...
2.
... if it contains detergent or fabric softener residue.
1.
Pull out, depress insert, completely remove.
2.
Open the cover.
2* Carefully unscrew pump cover until the detergent solution begins to run out.
3.
Clean with water and dry.
4.
Close and lock the cover (place cylinder on guide pin).
5.
Insert detergent drawer.
3.
4.
Leave detergent drawer open so that residual water can evaporate.
5.
6.
Drum
Leave washing machine door open so that the drum can dry out.
Rust stains use chlorine free cleaning agent, not steel wool.
Descaling
No washing in the machine!
Descale according to the instructions of the descaling agent manufacturer, not required for
correct detergent dosage
1.
2.
Information to indicator lights
3.
4.
5.
Indicator lights for status displays and/or buttons flash:
6.
Indicator lights
Close the washing machine door properly; washing may be
7.
Rinse and Wash flash
caught.
Indicator lights
Clean detergent solution pump (page 9), outlet pipe/drainage
Spin and Rinse flash
hose blocked.
Indicator lights
Turn on the tap, supply hose kinked/jammed;
8.
Spin and Wash flash
clean filter (page 9), water pressure too low.
All indicator lights flash
Turn off the tap and call customer service.
7
8 8
Risk of scalding!
What to do if ...
Allow detergent solution to cool down!
Turn off the tap!
Detergent solution pump
F
Water is running out.
Set programme selector to Off, pull out the mains plug.
F
Water not flowing in.
Open and remove service flap.
Detergent not washed in.
For models with drainage hose:
Take drainage hose out of the holder and pull out of the
F
Washing machine door
housing.
cannot be opened.
Remove sealing cap, allow detergent solution to flow
F
Programme does not start.
out.
Press on sealing cap and insert drainage hose into the
holder.
F
Detergent solution is not
For models without drainage hose:
drained.
F
Washing not spun correctly.
When the service flap is half full, screw back the pump cover and empty the
service flap.
Repeat steps until all the detergent solution has run out.
F
Spin cycle actuated several
times.
Carefully unscrew the pump cover (residual water).
F
Water not visible in the drum. - Not a fault - water below the visible area
Clean the interior, pump cover thread and pump housing (fan impeller in the
F
Residual water in the
detergent solution pump must rotate).
dispenser for care product.
F
Odour formation in the
washing machine.
Reinsert and screw on pump cover.
F
Foam is coming out of the
detergent drawer.
Insert and close service flap.
To prevent unused detergent from flowing into the outlet during the next wash:
b
Pour 1 litre of water into dispenser II and select the Drain
programme.
F
Vibrations during spin cycle.
Filters in the water supply
Release water pressure in the supply hose:
Turn off the tap!
F
Display panel/indicator lights
Select any programme (except Spin
B
/Drain
b
).
do not function while the
Press Start/Pause
M
. Leave programme for approx. 40 seconds.
appliance is running.
Set programme selector to Off.
F
Programme progress longer
Remove hose from tap.
Clean filter with small brush.
than usual.
Depending on the model, remove hose from the rear
F
Detergent residue on the
of the appliance and clean the filter.
washing.
F
If a fault cannot be rectified or a repair is required:
Connect the hose and check for leaks.
- Set programme selector to Off and pull out the mains plug.
- Turn off the tap and call customer service (Installation instructions).
9
Safety instructions
- Correctly attach/replace drainage hose.
- Read and follow the operating and installation instructions and all other information enclosed
- Tighten screw fitting on the supply hose.
with the washing machine.
- Start/Pause
M
not selected?
- Retain documents for subsequent use.
Risk of electric shock
- Never pull out the mains plug by tugging the power cord!
- Tap not open?
- Filter blocked? Clean filter (page 9).
- Never insert/pull out the mains plug with damp hands.
Risk of injury
- Washing machine door may become very hot.
- Supply hose kinked or jammed?
- Safety function active.
- Caution when draining hot detergent solution.
- Do not climb on the washing machine.
M
- Do not lean on the open washing machine door.
- Start/Pause
selected?
Risk of poisoning
- Keep detergents and care products out of the reach of children.
- Door closed?
Risk of suffocation
- Keep packaging, plastic film and packaging parts out of the reach
- Clean detergent solution pump (page 9).
of children.
- Clean outlet pipe and/or drainage hose.
Danger to life
On redundant appliances:
- Distribute small and large items of washing in the drum.
- Pull out the mains plug.
- Sever the power cord and discard together with the plug.
- Not a fault - unbalanced load detection system adjusts
- Destroy the lock on the washing machine door. This will prevent
imbalance.
children from locking themselves in and suffocating.
Risk of explosion
- Caused by detergents containing solvents, e.g. stain remover/
items of washing pretreated with solvent naphtha may result in an
explosion after being loaded into the washing machine.
- Not a fault effect of the care product not impaired.
Beforehand thoroughly rinse items of washing by hand.
- Run Cottons y 90 ºC programme without washing.
Use standarddetergent.
Consumption values
- Too much detergent used?
Mix 1 tablespoon of fabric conditioner with ½ litre of water
and pour into dispenser II in the detergent drawer.
Programme
Load
- Reduce detergent dosage for the next wash cycle.
- Appliance feet fixed?
Cottons y 40 ºC
7 kg
Secure appliance feet (Installation instructions).
Cottons y Stains
Ã
60 ºC
7 kg
- Transportation safety devices removed?
Cottons y 90 ºC
7 kg
Remove transportation safety devices
Easy care
A
40 ºC
3 kg
(Installation instructions).
- Power failure?
Delicate q 30 ºC
2 kg
- Fuse tripped? Switch on/replace fuse.
Wool
U
30 ºC
2 kg
- If the fault occurs repeatedly, call customer service.
- Not a fault - unbalanced load detection system adjusts
* The values deviate from the indicated values depending on water pressure, water hardness, water
imbalance by repeatedly distributing the washing.
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
detergent, fluctuations in the mains voltage and selected additional functions.
- Occasionally phosphate free detergents contain
water insoluble residue.
- Select Rinse K or brush the laundry after washing.
10
Washing machine
Current*
Water*
Programme
duration*
Operating instructions
1,00 kWh
62 l
1:50 h
1.19 kWh
55 l
2:15 h
2,30 kWh
70 l
2:05 h
0,55 kWh
48 l
1:15 h
0.05 kWh
44 l
0:35 h
0.20 kWh
32 l
0:53 h
Read these instructions before switching on the washing machine!
Also follow the separate installation instructions.
Follow the safety instructions on page 11!
11
en