Bosch WAE20060UC/23 매뉴얼 - 페이지 4
{카테고리_이름} Bosch WAE20060UC/23에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WAE20060UC/23 6 페이지.
Bosch WAE20060UC/23에 대해서도 마찬가지입니다: 설치 지침 (5 페이지)
페이지 인쇄
_z
©
o
ZII
_2
=l.J
o
i_
O
CO
i_° I"
8
=1._
i
k2
=i
,o
Ot
k2 k2
i
..c:
8_
i
,o
_t
0._
I
]
}
2
.1
I
I
I
.1
(.
i
"4
2£"
0)
3
L2
!
C¢3
£
rm
c>
i
./
§
E_
s:s
_, So
Set cycle selector to Off, unplug the washer.
Open and remove service door.
Remove screws holding cover in place. Remove
begins transparent plastic cover.
Carefully unscrew pump cover until the water suds
begins to run out. When the service door is half full,
screw back the pump cover and empty the service
door.
Repeat steps until all the detergent solution has run out.
Carefully unscrew the pump cover (residual water).
Clean the interior, pump cover thread and pump housing (fan impeller in the
detergent-solution pump must rotate).
Reinsert and screw on pump cover.
Place transparent plastic cover and secure with screws provided.
Insert and close service door.
i
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 quart (approx. 1 liter) of water into dispenser II and select the Brain cycle.
"_%
_
= 7/_
_
_
......
I--i
i
ilIBii
Set cycle selector to Off pull out the mains plug.
:i
Loosen the hose clamp carefully remove the drainage hose (residual water).
9@_/
Clean the drainage hose and siphon connecting piece.
/_/
Reattach the drainage hose and secure the connection with the hose clamp.
r pressure in the supply hoses'
'_?
auoet
Select desired cycle (except for Spin/Drain).
Select Start. Let cycle run approx. 40 seconds.
Set cycle selector to Off. Unplug from main power supply!
Cleaning screen:
Remove hose from water faucet.
- Rinse the strainers under flowing water.
- Remove hoses on the rear
take out screen with pliers and clean.
Replace hose and check for leaks.