Bosch WAE24271AU 사용 설명서 - 페이지 2
{카테고리_이름} Bosch WAE24271AU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WAE24271AU 8 페이지. Bosch machine
![Bosch WAE24271AU 사용 설명서](/uploads/products/server2/1364321/1364321.png)
Safety instructions
Care
- Read and follow the operating and installation instructions and all other information enclosed
with the washing machine.
- Retain documents for subsequent use.
Risk of electric shock
- Never pull out the mains plug by tugging the power cord!
- Never insert/pull out the mains plug with damp hands.
Risk of injury
- Washing machine door may become very hot.
- Caution when draining hot detergent solution.
- Do not climb on the washing machine.
- Do not lean on the open washing machine door.
1.
- Do not touch the drum in case it is still spinning.
- Caution when opening the detergent drawer while washing
machine is running!
2.
Risk of poisoning
- Keep detergents and care products out of the reach of children.
3.
Risk of suffocation
- Keep packaging, plastic film and packaging parts out of the reach
of children.
4.
Danger to life
On redundant appliances:
- Pull out the mains plug.
- Sever the power cord and discard together with the plug.
5.
- Destroy the lock on the washing machine door. This will prevent
children from locking themselves in and suffocating.
Risk of explosion
- Caused by detergents containing solvents, e.g. stain remover/
items of washing pretreated with solvent naphtha may result in an
explosion after being loaded into the washing machine.
Beforehand thoroughly rinse items of washing by hand.
Consumption values
Programme
Load
Current**
Water**
Programme
duration**
ã
6.5 kg
0.65 kWh
56 l
2:51 h
Cottons y Stains
40 ºC *
ã
Cottons y Stains
60 ºC
6.5 kg
1.30 kWh
56 l
3:09 h
Cottons y Eco j 60 ºC
6.5 kg
1.19 kWh
47 l
2:35 h
Cottons y Stains
ã
90 ºC
6.5 kg
2.00 kWh
66 l
2:31 h
Information on the display panel
Easy Care
A
40 ºC
3 kg
0.55 kWh
48 l
0:59 h
Mixed Load à 30 ºC
3 kg
0.35 kWh
48 l
0:52 h
E2
Delicate/Silk æ 30 ºC
2 kg
0.28 kWh
48 l
0:44 h
Wool/
u U
30 ºC
2 kg
0.20 kWh
32 l
0:53 h
E3
E5
* Programme setting with maximum spin speed for testing according to or in accordance
E6
with AS/NZS 2040.2 and AS/NZS 6400.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
E8
detergent, fluctuations in the mains voltage and selected additional functions.
7
8
Risk of electric shock!
Maintenance
Pull out the mains plug!
Risk of explosion! No solvents!
Machine housing, control panel
Detergent solution pump
- Wipe with a soft, damp cloth.
Set programme selector to Off, pull out the mains plug.
- Do not use any abrasive cloths, sponges or cleaning agents (stainless steel cleaner).
1.
Open and remove service flap.
- Immediately remove washing and cleaning agent residue.
- Do not clean the appliance with a water jet.
Clean the detergent drawer ...
For models with drainage hose:
2.
Take drainage hose out of the holder and pull out of the
... if it contains detergent or fabric softener residue.
housing.
Remove sealing cap, allow detergent solution to flow
Pull out, depress insert, completely remove.
out.
Press on sealing cap and insert drainage hose into the
holder.
Open the cover.
For models without drainage hose:
2* Carefully unscrew pump cover until the detergent solution begins to run out.
Clean with water and dry.
When the service flap is half full, screw back the pump cover and empty the
service flap.
Close and lock the cover (place cylinder on guide pin).
Repeat steps until all the detergent solution has run out.
Insert detergent drawer.
3.
Carefully unscrew the pump cover (residual water).
4.
Clean the interior, pump cover thread and pump housing (fan impeller in the
detergent solution pump must rotate).
Leave detergent drawer open so that residual water can evaporate.
5.
Reinsert and screw on pump cover.
6.
Insert and close service flap.
Drum
Leave washing machine door open so that the drum can dry out.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and select the
Rust stains use chlorine free cleaning agent, not steel wool.
Descaling
No washing in the machine!
Drainage hose at the siphon
Descale according to the instructions of the descaling agent manufacturer, not required for
correct detergent dosage
Set programme selector to Off, pull out the mains plug.
1.
Loosen the hose clamp, carefully remove the drainage hose (residual water).
2.
Clean the drainage hose and siphon connecting piece.
3.
Reattach the drainage hose and secure the connection with the hose clamp.
Filters in the water supply
Motor fault. Call customer service!
Release water pressure in the supply hose:
Close the washing machine door properly; washing may be caught.
1.
Turn off the tap!
2.
Select any programme (except
Turn on the tap, supply hose kinked/jammed;
3.
Press Start/Pause
clean filter -> page 10, water pressure too low.
4.
Set programme selector to Off.
Detergent solution pump blocked; clean the detergent solution pump -> page 10.
5.
Remove hose from tap.
Drainage hose / waste pipe blocked; clean the drainage hose at the siphon ->
6.
Clean filter with small brush.
page 10.
7.
Depending on the model, remove hose from the rear
of the appliance and clean the filter.
Turn off the tap and call customer service.
8.
Connect the hose and check for leaks.
9
Risk of scalding!
What to do if ...
Allow detergent solution to cool down!
Turn off the tap!
F
Water is running out.
- Correctly attach/replace drainage hose.
- Tighten screw fitting on the supply hose.
F
Water not flowing in.
- Start/Pause
Detergent not washed in.
- Tap not open?
- Filter blocked? Clean filter -> page 10.
- Supply hose kinked or jammed?
F
Washing machine door
- Safety function active. Wait approx. 2 minutes.
cannot be opened.
- ---- (without final spin) selected?
F
Programme does not start.
- Start/Pause
- Door closed?
F
Detergent solution is not
- Clean detergent solution pump -> page 10.
drained.
- Clean outlet pipe and/or drainage hose.
F
Washing not spun correctly.
- Distribute small and large items of washing in the drum.
F
Spin cycle actuated several
- Not a fault - unbalanced load detection system adjusts
imbalance.
times.
F
Water not visible in the drum. - Not a fault - water below the visible area
F
Residual water in the
- Not a fault effect of the care product not impaired.
dispenser for care product.
F
Odour formation in the
- Run Cottons y Stains
washing machine.
washing. Use standard detergent.
F
Foam is coming out of the
- Too much detergent used?
detergent drawer.
Mix 1 tablespoon of fabric softener with ½ litre of water and
pour into compartment II (not with outdoor fabrics!).
- Reduce detergent dosage for the next wash cycle.
b
Drain programme.
F
Vibrations during spin cycle.
- Appliance feet fixed?
Secure appliance feet -> Installation instructions.
- Transportation safety devices removed?
Remove transportation safety devices
-> Installation instructions.
F
Display panel/indicator lights
- Power failure?
do not function while the
- Fuse tripped? Switch on/replace fuse.
appliance is running.
- If the fault occurs repeatedly, call customer service.
F
Programme progress longer
- Not a fault - unbalanced load detection system adjusts
than usual.
imbalance by repeatedly distributing the washing.
- Not a fault - foam detection system active a rinse cycle is
started.
B
b
Spin/
Drain).
M
F
Detergent residue on the
- Occasionally phosphate free detergents contain
. Leave programme for approx. 40 seconds.
washing.
water insoluble residue.
- Select Rinse/Freshen up K or brush the laundry after
washing.
F
If a fault cannot be rectified or a repair is required:
- Set programme selector to Off and pull out the mains plug.
- Turn off the tap and call customer service -> Installation instructions.
10
M
not selected?
M
selected?
Washing machine
ã
90 ºC programme without
Operating instructions
Read these instructions before switching on the washing machine!
Also follow the separate installation instructions.
Follow the safety instructions on page 8!
11
en