Draper XT1000VB 설치 및 작동 지침 - 페이지 7
{카테고리_이름} Draper XT1000VB에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper XT1000VB 7 페이지. Electric projection screen
페이지 인쇄
Ultimate Access E and V
Section 13 - Accessing Built-In Low-Voltage Control Unit
PLEASE NOTE: Applies ONLY if Unit is built into case.
1.. Locate junction box on motor end of screen.
2. Remove the four
hex head screws from the junction box.
(4)
3. Remove the L-bracket with the LVC-IV from the junction box.
Section 14 - Wiring Diagrams
Standard and Quiet Motors
110-120V MOTOR
STANDARD
Single Station Control
Internal Screen Wiring
White (Common)
Black (Down)
Red (Up)
Green (Ground)
Dashed wiring
by electrician.
Single gang box by others.
Control
Min. 4" x 2 ⁄ " x 1 ⁄ " deep.
switch
(102mm x 54mm x 48mm)
Blue
Red
Black
Location of key
operated on-off
switch if furnished.
To 110-120V Line
Internal LVC-IV - Single or Multiple Projection Screen Wiring Diagram
INTERNAL SCREEN WIRING
Green/Yellow
(Motor Ground)
Red
(Up)
Black (Down)
White
(Common)
White-Common to screen & 110V-120V AC Neutral
GND
N
L1
Location of key operated
ON-OFF SWITCH (if supplied)
.
(Fig. 11)
Figure 11
Please Note: Do not wire motors in parallel.
Green/Yellow
(Ground)
Red-to screen (directional)
Brown-to screen (directional)
Black-to 110V-120V AC-Hot
Yellow-to 110V-120V AC-Hot
DASHED WIRING BY ELECTRICIAN
Low-Voltage wiring by Others
FACTORY WIRING
(LVC-IV)
MOTOR END OF CASE
External LVC-IV
Receiver
Button
Internal
LVC-IV
page 7 of 7
(Bottom View)
2.214"
4.5"
(56mm)
(114mm)
LVC-S: 3 BUTTON WALL SWITCH
PN: 121225
BACK
BLACK - DOWN
WHITE - COMMON
RED - UP
RS232/485
Inputs/Outputs
RJ25
Connector
(Ports are identical)
ELECTRICALLY STRAIGHT DATA CABLE
1 - WHITE -1
2 - BLACK - 2
3 - RED - 3
4 - GREEN - 4
5 - YELLOW - 5
IR Eye
6 - BLUE - 6
Input
Data Cable to more LVC-IV Modules (6 Max)
IR Eye
Max Cable Length:
Low-Voltage
42" (1 meter)
Trigger
4-28 VDC
LVC-IV Unit
Location
10.39"
(264mm)
RJ25
Connector