Bosch wae28462gb 사용 설명서 및 설치 지침 - 페이지 31
{카테고리_이름} Bosch wae28462gb에 대한 사용 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch wae28462gb 36 페이지.
페이지 인쇄Water connection
:
Warning
Risk of death!
There is a risk of electric shock if live
components are touched.
Do not immerse the AquaStop safety
valve in water (it contains an electric
valve).
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
leaks and water damage, you must
follow the instructions in this section.
Observe the following when connecting
the machine:
Notes
In addition to the information listed
■
here, the local water and electricity
supplier may have special
requirements.
Only operate the washing machine
■
using cold mains water.
Do not connect the washing
■
machine to the mixer tap of an
unpressurised hot-water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
If in doubt, have the appliance
■
connected by a technician.
Positioning and connecting
Water inlet
Notes
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw connection by
■
hand. If the screw connections are
tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow
■
rate is at least 8 l/min.
If the water pressure is higher than
■
this, a pressure-reducing valve must
be installed.
Connection
Connect the water supply hose to the
tap (¾" = 26.4 mm) and to the
appliance (not necessary for AquaStop
models as this is permanently installed):
Standard model
■
AquaSecure model
■
en
31