Draper 13274 사용 설명서 - 페이지 8
{카테고리_이름} Draper 13274에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 13274 16 페이지. 12v analogue tyre inflator
페이지 인쇄
5.
HEALTH AND SAFETY INFORMATION
Check damaged parts. Before further use of this inflator, parts that are damaged should be
carefully checked to ensure that it will operate correctly and perform its intended function. Check
for alignment of moving parts, breakage of parts and any other conditions that may effect its
operation. A guard or other part that is damaged should be properly repaired or replaced.
Disconnect from power supply. Before servicing, maintaining or replacing damaged parts
ALWAYS disconnect the inflator from the power supply.
Avoid dangerous environments. Do not use the inflator in damp or wet locations or expose it to
rain. Keep the work area well lit. Provide adequate surrounding work space.
Avoid accidental starting. Ensure the switch on the inflator is in the "OFF" position before
connecting to a power supply.
Never leave the inflator running unattended. Disconnect from the power supply. Do not leave
the inflator until it comes to a complete stop.
Use recommended accessories. Only use the recommended adaptors as supplied.
Overheating . Operation over an extended period of time will overheat the unit and damage the
inflator. When this occurs stop the unit immediately and do not restart until cool, approximately 20
minutes (depending on environmental conditions).
Keep children away. Ensure the inflator is stored out of reach of small children.
Tyre pressure. The gauge on the inflator is intended as a guide only. Tyre pressures should be
regularly checked against a tyre pressure gauge manufactured to BS4613.
Have this tool repaired by a qualified person. This tool is designed to confirm to the relevant
international and local standards and as such should be maintained and repaired by someone
qualified; using only original parts supplied by the manufacturer: This will ensure the tool remains
safe to use.
5.3
ADDITIONAL SAFETY INSTRUCTIONS FOR 12V AIR INFLATOR
− This product is designed for occasional use. Inflation over a long period may over heat and
cause damage to this product and potential harm to user.
− This product should not operate for more than
it must be switched off for at least
− Inspect your 12V Air Inflator and battery before each use. If damaged parts are found, have
this tool repaired by a qualified person.
− Never expose the inflator or battery to rain, frost or temperatures above
− Never use the inflator near flammable fluids or gasses. Make sure your area is well lit.
− Protect yourself against electric shock. Avoid contact with grounded surfaces such as pipes,
radiators, electric stoves, refrigerators etc.
− Never leave children unattended with this inflator.
− Never point or aim this product at other persons or animals. This air inflator is not a toy!
5.4
CONNECTION TO THE POWER SUPPLY
Caution: Risk of electric shock. Do not open.
This appliance is supplied with an approved plug and cable for your safety.
Never use a damaged or incomplete plug.
Position cable safely to avoid tripping over.
8 minutes at a time (Please
15 minutes. (Please confirm)
– 8 –
confirm). After which
50°C (Please confirm).