Draper 83652 사용 설명서 - 페이지 7

{카테고리_이름} Draper 83652에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 83652 16 페이지. 135w 230v rotary multi-tool kit with flexible drive shaft
Draper 83652에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

페이지 인쇄

HEALTH & SAFETY INFORMATION

g) If devices are provided for the connection of dust extraction and collection facilities,

ensure these are connected and properly used. Use of dust collection can reduce dust

related hazards.

4) Power Tool Use And Care

a) Do not force the power tool. Use the correct power tool for your application. The

correct power tool will do the job better and safer at the rate for which it was

designed.

b) Do not use the power tool if the switch does not turn it on and off. Any power tool

that cannot be controlled with the switch is dangerous and must be repaired.

c) Disconnect the plug from the power source and/or the battery pack from the power

tool before making any adjustments, changing accessories, or storing power tools.

Such preventive safety measures reduce the risk of starting the power tool

accidentally.

d) Store idle power tools out of the reach of children and do not allow persons

unfamiliar with the power tool or these instructions to operate the power tool.

Power tools are dangerous in the hands of untrained users.

e) Maintain power tools. Check for misalignment or binding of moving parts, breakage

of parts and any other condition that may affect the power tools operation. If

damaged, have the power tool repaired before use. Many accidents are caused by

poorly maintained power tools.

f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp

cutting edges are less likely to bind and are easier to control.

g) Use the power tool, accessories and tool bits etc., in accordance with these

instructions, taking into account the working conditions and the work to be

performed. Use of the power tool for operations different from intended could result

in a hazardous situation.

5) Service

a. Have your power tool serviced by a qualified repair person using only identical

replacement parts. This will ensure that the safety of the power tool is maintained.

5.2

ADDITIONAL SAFETY INSTRUCTIONS FOR MULTI-TOOL USE

Sander Safety Warning

1) Personal Safety

a) Wear dust protection with sanders. Exposure to dust can be detrimental to health.

b) Connect dust extraction equipment. If the tool is provided for the connection of dust

extraction and collecting equipment, ensure these are connected and properly used.

Working hints for your tool.

If your power tool becomes too hot, especially when used at low speed, set the speed to

maximum and run it with no load for 2-3minutes to cool the motor. Avoid prolonged

usage at very low speeds. Always keep the blade sharp.

Always ensure the workpiece is firmly held or clamped to prevent movement.

Any movement of the material may effect the quality of the cutting or sanding finish.

Start your tool before working and turn it off only after you stop working.

Do not start sanding without having the sandpaper fitted.

Do not allow the sandpaper to wear away, it will damage the sanding pad. The

guarantee does not cover sanding pad wear and tear.

Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces and fine

grit for the finishing surfaces. If necessary, first make a test run on scrap material.

Excessive force will reduce the working efficiency and cause motor overload. Replacing

the accessory regularly will maintain optimum working efficiency.

Maintain tool with care