Draper D16/16F 사용 설명서 - 페이지 10
{카테고리_이름} Draper D16/16F에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper D16/16F 20 페이지.
페이지 인쇄
8. Screw the three downfeed handles
the three holes located in the pinion shaft as
shown in Fig 8.
9. Making sure that the chuck
its capacity, place it down on a bench. Clean
any excess grease off the large end of the
spindle
. Insert the taper into the back of
the chuck and with a scrap piece of timber
and a hammer firmly tap them together.
10. Loosen the nut and bolt
slide the chuck guard
. Tighten the nut and bolt and lift the guard
into the upright position.
11. Now clean the other end of the arbor
Fig.11 from grease and offer it up to the
spindle
. Rotate the arbor and chuck until
the flats on the arbor engage into the spindle
. Then firmly tap once using a hammer and
scrap piece of timber. Should it be required,
removal of the arbor from the spindle is
achieved by lowering the spindle, and with the
depth gauge, lock it in the down position. On
the side of the spindle is a hole which exposes
the top of the arbor (if this cannot be seen
fully, rotate the chuck slightly). Now using the
tool provided, tap into the hole forcing the
arbor down and out.
ASSEMBLY
is opened to
Fig.10 and
up onto the collar
into
Fig.8.
Fig.9.
Fig.10.
Fig.11.
- 9 -