Draper D16/16F 사용 설명서 - 페이지 4

{카테고리_이름} Draper D16/16F에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper D16/16F 20 페이지.

CONNECTING YOUR MACHINE TO THE POWER SUPPLY: (230V)

To eliminate the possibility of an electric shock your machine has been fitted with a BS

approved, non rewireable moulded plug and cable which incorporates a fuse, the value

of which is indicated on the pin face of the plug. Should the fuse need to be replaced an

approved BS1362 fuse must be used of the same rating, marked thus

The fuse cover is detachable, never use the plug with the cover omitted. If a replacement

fuse cover is required, ensure it is of the same colour as that visible on the pin face of the

plug (i.e. red). Fuse covers are available from your Draper Tools stockist.

If the fitted plug is not suitable, it should be cut off and destroyed. *The end of the cable

should now be suitably prepared and the correct type of plug fitted. See below.

*WARNING:

A plug with bare flexible wires exposed is hazardous if engaged in a live power socket

outlet.

WARNING: THIS APPLIANCE IS DOUBLE INSULATED.

Blue – Neutral, Brown – Live.

As these colours may not correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with

the letter 'N' or coloured black or blue.

The wire which is coloured brown must be connected to the terminal which is marked

with the letter 'L' or coloured red or brown.

EXTENSION LEAD CHART:

Extension lead sizes shown assure a voltage drop of not more than 5% at rated load of tool.

Ampere rating

(on Name plate)

Extension cable length

7.5m

15m

22.5

30M

45M

POWER SUPPLY

0.75

Wire Size mm2

0.75

1.25

- 3 -

1.0

1.25

1.0

1.5

1.0

1.5

1.25

1.5

2.5