Bosch WAK24268IN 사용 설명서 및 설치 지침 - 페이지 28

{카테고리_이름} Bosch WAK24268IN에 대한 사용 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WAK24268IN 40 페이지.
Bosch WAK24268IN에 대해서도 마찬가지입니다: 사용 설명서 및 설치 지침 (40 페이지)

페이지 인쇄

Faults and what to do about them.

Information on the display panel

Display

YES

¼ flashes

E:17

E:18

E:23

N flashes

Other displays

Cause/remedial action

The washing machine door is unlocked. It is possible to add laundry.

The temperature is too high. Wait until the temperature falls.

■

Water level too high. Not possible to add laundry. If necessary, close the wash-

■

ing machine door immediately. To continue the programme, press Start/

Reload A .

Laundry may be caught. Please open and close the washing machine door

■

again and press Start/Reload A .

If necessary, push the washing machine door closed or remove the laundry and

■

push it closed again.

If necessary, switch the appliance off and on again; set the programme and

■

make your individual settings; start the programme.

Turn the water tap on fully,

■

The supply hose is kinked/trapped,

■

The water pressure is too low.

■

– Clean the filter in the water supply. ~ Page 26

– If an additional water filter has been installed (depending on model)

~ Page 35, check for contaminants and clean if required ~ separate

installation and cleaning instruction for water filter.

The detergent solution pump is blocked. Clean the detergent solution pump.

■

~ Page 25

The drain hose/waste pipe is blocked. Clean the drain hose at the siphon.

■

~ Page 25

Water in the base tub, appliance leaking. Turn off the water tap. Call the after-sales

service. ~ Page 31

The childproof lock is activated; to deactivate: ~ Page 20

Too much foam detected, a rinse cycle has been switched on.

The mains voltage is too low. ~ Page 22

Undervoltage in the wash programme. The programme is extended. ~ Page 31

Switch off the appliance, wait for 5 seconds and switch it back on again. If the dis-

play appears again, call the after-sales service. ~ Page 31